GE JX36CSS Installation Manual
Installation Filler Panel Kit
Instructions
JX36
FOR 36” INSTALLATIONS
Kit Model
JX36B CVM1750/CVM1790/PVM9179/
CSA1201/PSA9120/PSA9240
JX36C JVM6170/JNM6171/JVM6172/
JVM6175/JVM6177
JX36D JVM7195/DVM7195/JNM7196/
PVM9195/PNM9196/PVM9215
TOOLS YOU WILL NEED
• Phillips screwdriver
PARTS INCLUDED
• Trim kit side mount (2)
• Connecting Bar (1)
• Installation screws (2)
49-40720-1 10-14 GE
Installation Instructions
Install the OTR bracket according to OTR
Installation Instructions.
NOTE: This kit is best installed with 12” base
cabinets. Cabinets with greater than a 12” base
may have a larger gap between back wall and kit.
NOTE: Ensure the OTR and the Cooking Product
installation manuals are followed.
OTR Bracket
KIT INSTALLATION
1. Place the microwave on a flat surface where you
can work on the bottom of both sides.
2. Remove all 3 pieces from the package (right
panel, left panel, top brace.
3. Remove the screws from the lower back of the
microwave.
4. With the short edge of the side trim to the back
of the left side of the microwave, and using the
screw you just removed, attach the side trim to
the back of the microwave.
Screw
Holes
5. Your microwave will have one or two screws on
the bottom left side. Remove these screws to
create a gap between the bottom plate and the
case of the microwave.
6. Slide the lower lip of the side panel inside the gap
between the bottom plate and the case. Attach
using the screws you removed in step 5.
Printed in USA
7. Make adjustments so the side panel is in line with
the front of the microwave case.
Flush with front of
microwave case.
8. Repeat the same procedure for the other side.
9. Using the 2 flat head screws provided, attach the
top brace to the 2 side panels to pull both panels
together.
10. Install the over-the-range microwave with side
panels into the 36” opening.
NOTE: Make sure you have installed the mounting
wall bracket in the center of the 36” opening per
the installation instructions provided with your
microwave.
2
Loading...