GE JX2200NBB, JX2201NSS, ZX2201NSS Installation Guide
GEConsumer & Industrial Appliances
Ass mblg Instructions
Advantium ®240V Built-ln Accessory Storage Drawer
JX2200, JX2201, ZX2201
BEFORE YOU BEGIN
Readtheseinstructionscompletelyand carefully.Read
the InstallationInstructionsfor theAdvantium 240Voven
completely and carefullyfor cutout dimensionsand
step-by-stepinstructions.
IMPORTANT- Save these instructions for
local inspector's use.
IM PORTANT- Observe allgoverning codes
and ordinances.
• NOTE TO INSTALLER: Be sure to leave these
instructions with the Consumer.
• NOTE TO CONSUMER: Keep these instructions with
your Advantium 240V Oven Owner's Manual for
future reference.
• SKILL LEVED Installation of this appliance requires
basic mechanical skills.
• COMPLETION TIME: One hour with the installation
of an Advantium 2/40Voven.
• Proper installation isthe responsibility of the installen
• Product failure due to improper installation is not
covered under the Warranty. See the Advantium
240V Oven Owner's Manual for warranty information.
MODELS AVAILABLE
Profile Models:
JX2200BB-Black
JX2201SS-StainlessSteel
Monogram Models:
ZX2201SS-Stainless Steel
NOTE:Advantium 240V Built-In Speedcook Oven
model ZSC2202SS CANNOT be installed with an
accessorg storage drawer. See Installation
Preparation Without an Accessory Storage Drawer
in the Advantium 240V Built-In SpeedCook Oven
Installation Instructions for this model.
PRODUCT DIMENSIONS AND CLEARANCES
[u0 i 0° ._5"
Allow 15" clearance
when fully open
NOTE:Appearance will vary bg model.
TOOLS REQUIRED
• #2 Phillipsscrewdriver
PARTSSUPPLIED
• 2 SideSupports
• Screws
• Screws(color matched)
SPECIFICATIONSSUBJECTTOCHANGEWITHOUTNOTICE MFL06213303 49-/40575:12-07JR
ASSEMBLYTO ADVANTIUM 240V BUILT-IN SPEEDCOOK OVEN
[] REMOVE PACKAGING AND PARTS
• Remove the drawer from the carton.
• Remove all packing material and tape.
• Open the drawer and remove anu parts inside.
• Locate parts.
Assernblg
Instructions
Side Supports (2)
Assemblg Color Hotched BrassScrews
Instructions Screws (/4required,
(/4required, 2extra)
i e×tra)
ASSEMBLING THE OVEN TO DRAWER
[]
[]
Place storage drawer on a surface with the
front of drawer hanging over the edge of the
surface. Not placing the front edge of drawer
over the edge of the surface mau result in
damage to the drawer since the front edge of
drawer hangs below the bottom of drawer.
[]
Place the oven on top of the storage drawer.
Hake sure that the back and sides of the oven
align with the back and sides of drawer.
ASSEMBLINGTHEOVENTO DRAWER
(CONT.)
[] Remove the front two bottom screws on each
side of the oven and the top center screw on
each side of the storage drawer.
/
/
J
[] Place the side supports into the tabs on the
drawer and secure using the screws supplied
and the screws removed in Step C.
!
NOTE: The bottom of the oven side flanges will
sit directlu in front of the top of the storage
drawer side flanges.
Printed in Korea 2
[] The oven and storage drawer assemblu is now
read U to be installed. Return to the Advantium
240V Built-In SpeedCook Oven Installation
Instructions to complete the installation.
Loading...