GE JVM1850BH, JVM1850CH, JVM1850SH, JVM1850WH Specification

GE Appliances

JVM1850BH/CH/SH/WH – GE Spacemaker® Over-the-Range Microwave Oven

Dimensions (in inches)

	66" MIN.	30"
	Mounting	MIN.
	height	width	Exhaust outlet
	from	required
			connects to
	floor
			3-1/4" X 10" duct
		12"
		MIN.
		15-1/4
		16-13/32
	21-3/4"	16
	Door open

Note: Requires 120V grounded outlet. Electrical receptacle must be located in cabinet above Spacemaker microwave oven. No additional wiring, venting or cabinet rebuilding necessary in many cases. Complete detailed, easy-to-follow installation instructions and convenient full-size templates are packed with the Spacemaker microwave oven.

Important Information: When installing the Spacemaker microwave oven over a range, allow minimum of 2" from bottom of Spacemaker microwave oven to top of range backguard to allow for removal of light covers.

Ventilation Options: The Spacemaker microwave ovens are designed for adaptation to the following three types of ventilation:

•Outside exhaust (vertical – as shown)

•Outside exhaust (horizontal)

•Recirculating (non-vented ductless – see Filter Kit drawing)

Installation Information: This information is not intended to be used for installing unit described. Before installing, consult installation instructions packed with product/kit for current dimensional data.

29-7/8

	Listed by
	Underwriters
R	Laboratories

	For answers to your Monogram,® GE Profile™ or
Specification Created 10/03	GE® appliance questions, visit our website at
	GEAppliances.com or call
340105	GE Answer Center® service, 800.626.2000.

GE Appliances

JVM1850BH/CH/SH/WH – GE Spacemaker® Over-the-Range Microwave Oven

Optional Accessories (Available at additional cost)

Filler Panel Kits

JX52WH–White

JX52BL–Black

When replacing a 36" or 42" range hood, this kit fills in the additional width to provide a custom built-in appearance. For installation between cabinets only; not for end-of-cabinet installation. Each kit contains two 3"-wide filler panels.

Filter Kits

JX81B–Recirculating Charcoal Filter Kit

To be used when the Spacemaker microwave oven cannot be vented to the outside.

HOOD EXHAUST DUCT: Outside ventilation requires a HOOD EXHAUST DUCT. Read the following carefully.

EXHAUST CONNECTION: The hood exhaust has been designed to mate with a standard 3-1/4" x 10" rectangular duct. If a round duct is required, a rectangular-to-round transition adaptor must be used. Do not use less than a 6” diameter duct

REAR EXHAUST: If a rear or horizontal exhaust is to be used, care should be taken to align exhaust with space between studs, or wall should be prepared at the time it is constructed by leaving enough space between the wall studs to accommodate exhaust.

MAXIMUM DUCT LENGTH: For satisfactory air movement, the total duct length of 3-1/4" x 10" rectangular or 6" diameter round duct should not exceed 140 equivalent feet.

ELBOWS, TRANSITIONS,WALL AND ROOF CAPS, etc., present additional resistance to airflow and are equivalent to a section of straight duct which is longer than their actual physical size. When calculating the total duct length, add the equivalent length of all transitions and adaptors plus the lengths of all straight duct sections. The chart below shows the approximate feet of equivalent length of some typical ducts.

Duct	Equivalent Feet
A. Rectangular-To-round	5 ft.
Transition Adaptor
B. Wall Cap	40 ft.
C. 90° Elbow	10 ft.
D. 45° Elbow	5 ft.
E. 90° Elbow	25 ft.
F. 45° Elbow	5 ft.
G. Roof Cap	24 ft.

		For answers to your Monogram,® GE Profile™ or
		GE® appliance questions, visit our website at	Listed by
	Specification Created 10/03	GEAppliances.com or call	Underwriters
			Laboratories
	340105	R
		GE Answer Center® service, 800.626.2000.