GE JVM1790SK User Manual

JVM1790BK/CK/SK/WK

Over-the-Range Microwave Oven
Dimensions (in inches)

66" MIN.

Mounting

height

from floor

30" MIN.

width required

Exhaust outlet
connects to
3-1/4" X 10" duct

16-7/16

(Rear)

15-3/8

24-1/2

16-7/16

29-15/16

Minimum distance from
door hinge side to adjacent
wall should equal 1/2-inch.

(without
obstruction)

13"

MAX.

12"

MIN.

GE Profile™ 1.7 Cu. Ft. Capacity Over-the-Range Microwave Oven

Dimensions and Installation Information (in inches)

Note: Requires 120V grounded outlet. Electrical receptacle must be

located in cabinet above Spacemaker microwave oven. No additional
wiring, venting or cabinet rebuilding necessary in many cases. Complete
detailed, easy-to-follow installation instructions and convenient full-size
templates are packed with the Spacemaker microwave oven.

Important Information: When installing the Spacemaker microwave
oven over a range, allow minimum of 2” from bottom of Spacemaker
microwave oven to top of range backguard to allow for removal
of light covers.

Ventilation Options: The Spacemaker microwave ovens and
Spacemaker convection/microwave ovens are designed for
adaptation to the following three types of ventilation:

• Outside exhaust (Vertical – as shown)

• Outside exhaust (horizontal)

• Recirculating (non-vented ductless – see Filter Kit drawing, order
JX81, JX81A or JX81B)r

Installation Information: This information is not intended to be used for
installing unit described. Before installing, consult installation instructions
packed with product/kit for current dimensional data.

For answers to your Monogram,® GE Profile™ or
GE® appliance questions, visit our website at
ge.com or call GE Answer Center® service,

800.626.2000.

Specification Revised 8/07

Listed by
Underwriters
Laboratories

240260

JVM1790BK/CK/SK/WK

GE Profile™ 1.7 Cu. Ft. Capacity Over-the-Range Microwave Oven

Optional Accessories (Available at additional cost)

Hood Exhaust Duct: Outside ventilation requires a HOOD EXHAUST DUCT. Read the

following carefully.

Exhaust Connection: The hood exhaust has been designed to mate with a standard
3-1/4" x 10" rectangular duct. If a round duct is required, a rectangular-to-round
transition adaptor must be used. Do not use less than a 6" diameter duct.

Rear Exhaust: If a rear or horizontal exhaust is to be used, care should be taken to
align exhaust with space between studs, or wall should be prepared at the time it
is constructed by leaving enough space between the wall studs to accommodate
exhaust.

Maximum Duct Length: For satisfactory air movement, the total duct length of 3-1/4"
x 10" rectangular or 6" diameter round duct should not exceed 140 equivalent feet.

ELBOWS, TRANSITIONS, WALL AND ROOF CAPS: etc., present additional resistance to
airflow and are equivalent to a section of straight duct which is longer than their
actual physical size. When calculating the total duct length, add the equivalent length
of all transitions and adaptors plus the lengths of all straight duct sections. The chart
below shows the approximate feet of equivalent length of some typical ducts.

Duct Equivalent Feet

A. Rectangular-To-round

Transition Adaptor 5 ft.

B. Wall Cap 40 ft.

C. 90° Elbow 10 ft.

D. 45° Elbow 5 ft .

E. 90° Elbow 25 ft.

F. 45° Elbow 5 ft.

G. Roof Cap 24 ft.

Filler Panel Kits
JX46BL–Black
JX46WH–White

When replacing a 36" or
42" range hood, this kit fills
in the additional width to
provide a custom built-in
appearance.
For installation between
cabinets only; not for
end-of-cabinet installation.
Each kit contains two
3"-wide filler panels.

Filter Kits
JX81A–Recirculating

Charcoal Filter Kit

To be used when
the Spacemaker
microwave oven
cannot be vented
to the outside.

Specification Revised 8/07

Listed by
Underwriters
Laboratories

240260