GE JVM1650WH, JVM1650SH, JVM1650BH, JVM1650CH User Manual

GE Appliances

JVM1650BH/CH/SH/WH – GE Spacemaker®Over-the-Range Microwave Oven

Dimensions (in inches)

For answers to your Monogram,®GE Profile™or
GE®appliance questions, visit our website at
GEAppliances.com or call
GE Answer Center®service, 800.626.2000.

R

Listed by
Underwriters
Laboratories

Note: Requires 120V grounded outlet. Electrical receptacle must be located in
cabinet above Spacemaker microwave oven. No additional wiring, venting or
cabinet rebuilding necessary in many cases. Complete detailed, easy-to-follow
installation instructions and convenient full-size templates are packed with
the Spacemaker microwave oven.

Important Information: When installing the Spacemaker microwave oven
over a range, allow minimum of 2" from bottom of Spacemaker microwave
oven to top of range backguard to allow for removal of light covers.

Ventilation Options:The Spacemaker microwave ovens are designed for
adaptation to the following three types of ventilation:

• Outside exhaust (vertical – as shown)

• Outside exhaust (horizontal)

• Recirculating (non-vented ductless – see Filter Kit drawing)

Installation Information: This information is not intended to be used for
installing unit described. Before installing, consult installation instructions
packed with product/kit for current dimensional data.

Specification Created 10/03

340101

21-3/4"

Door open

29-7/8

66" MIN.

Mounting

height

from
floor

12"

MIN.

15-1/4

16

30"

MIN.

width

required

16-13/32

Exhaust outlet

connects to

3-1/4" X 10" duct

GE Appliances

JVM1650BH/CH/SH/WH – GE Spacemaker®Over-the-Range Microwave Oven

Specification Created 10/03

340101

R

Listed by
Underwriters
Laboratories

For answers to your Monogram,®GE Profile™or
GE®appliance questions, visit our website at
GEAppliances.com or call
GE Answer Center®service, 800.626.2000.

Optional Accessories (Available at additional cost)

HOOD EXHAUST DUCT: Outside ventilation requires a HOOD EXHAUSTDUCT. Read the following carefully.
EXHAUST CONNECTION: The hood exhaust has been designed to mate with a standard 3-1/4" x 10"

rectangular duct. If a round duct is required, a rectangular-to-round transition adaptor must be used.
Do not use less than a 6” diameter duct

REAR EXHAUST:If a rear or horizontal exhaust is to be used, care should be taken to align exhaust with space
between studs, or wall should be prepared at the time it is constructed by leaving enough space between the
wall studs to accommodate exhaust.

MAXIMUM DUCT LENGTH: For satisfactory air movement, the total duct length of 3-1/4" x 10" rectangular or
6" diameter round duct should not exceed 140 equivalent feet.

ELBOWS, TRANSITIONS,WALL AND ROOF CAPS, etc., present additional resistance to airflow and are
equivalent to a section of straight duct which is longer than their actual physical size. When calculating the total
duct length, add the equivalent length of all transitions and adaptors plus the lengths of all straight duct sections.
The chart below shows the approximate feet of equivalent length of some typical ducts.

Duct Equivalent Feet

A. Rectangular-To-round 5 ft.

Transition Adaptor

B. Wall Cap 40 ft.
C. 90° Elbow 10 ft.
D. 45° Elbow 5 ft.
E. 90° Elbow 25 ft.
F. 45° Elbow 5 ft.
G. Roof Cap 24 ft.

Filter Kits
JX81A–Recirculating

Charcoal Filter Kit

To be used when the
Spacemaker microwave
oven cannot be vented
to the outside.

Filler Panel Kits
JX48BL–Black
JX48WH–White

When replacing a 36" or 42"
range hood, this kit fills in the
additional width to provide a
custom built-in appearance.
For installation between
cabinets only; not for
end-of-cabinet installation.
Each kit contains two 3"-wide
filler panels.