For answers to your Monogram,
®
GE Profile Performance Series,
™
GE Profile™or GE appliance questions, call
GE Answer Center®service, 800.626.2000.
Listed by
Underwriters
Laboratories
Specification Revised 8/99
Optional Accessories (Available at additional cost)
Filler Panel Kits
JX40WH—White
When replacing a
36" or 42" range
hood, this kit fills in
the additional width to
provide a custom,
built-in appearance. For
installation between cabinets
only; not for end-of-cabinet
installation. Each kit contains
two, 3"-wide filler panels.
Two kits are needed
for a 42" opening.
Filter Kits
JX81—Recirculating Charcoal Filter Kit
To be used when the SpacemakerPlus
™
microwave convection oven cannot be
vented to the outside.
JX22SS—Stainless Steel Decorative
Panel Kit
When replacing a Hi/Low range with a
SpacemakerPlus
™
microwave oven over
a range model, this panel kit fills in the
area between the microwave and range
left by the Hi/Low model.
JVM1190SY - GE Profile Performance™SpacemakerPlus™1.1 Cu. Ft. Microwave/Convection Oven
HOOD EXHAUSTDUCT
Outside ventilation requires a HOOD EXHAUST DUCT. Read the following carefully.
EXHAUST CONNECTION: The hood exhaust has been designed to mate with a standard
3-1/4” x 10” rectangular duct.If a round duct is required, a rectangular-to-round transition adaptor
must be used. Do not use less than a 6” diameter duct
REAR EXHAUST:If a rear or horizontal exhaust is to be used, care should be taken to align
exhaust with space between studs,or wall should be prepared at the time it is constructed by
leaving enough space between the wall studs to accommodate exhaust.
MAXIMUM DUCT LENGTH: For satisfactory air movement, the total duct length of 3-1/4” x 10”
rectangular or 6” diameter round duct should not exceed 140 equivalent feet.
ELBOWS, TRANSITIONS,WALL AND ROOF CAPS, etc., present additional
resistance to airflow and are equivalent to a section of straight duct which is longer than their
actual physical size. When calculating the total duct length, add the equivalent length of all
transitions and adaptors plus the lengths of all straight duct sections. The chart below shows the
approximate feet of equivalent length of some typical ducts.
Duct Equivalent Feet
A. Rectangular-To-round 5ft.
Transition Adaptor
B. Wall Cap 40ft.
C. 90° Elbow 10ft.
D. 45° Elbow 5ft.
E. 90° Elbow 25ft.
F. 45° Elbow 5ft.
G. Roof Cap 24ft.