TM
JSP57BF/CF/WF – GE Profile™ 30" Slide-In Electric Range
Dimensions (in inches)
Accessory
Backguard
30 |
4 |
|
31-1/4 |
||
|
2-7/8" To Front
Surface Of Countertop
20-5/8" Door
Clearance
From Front
Surface of
Countertop
27-1/2
KW Rating
240V 12.0
208V 9.0
Breaker Size
240V 40 Amps
208V 40 Amps
30" Min. |
Shave Raised Edge To Clear |
||
31-1/8" Wide Control Panel |
|||
6" Min. |
|
|
|
From Walls |
9/16 |
||
30" Min. |
|
|
|
23-3/16 |
Acceptable |
|
|
Electrical |
13" Max. |
||
|
|||
|
Outlet Area |
15" Min. |
|
|
|
||
|
|
25 |
|
36 |
|
|
|
2-1/2 |
|
|
|
|
|
7-1/2 |
|
30 |
|
2-1/2 |
|
|
|
If you are NOT using the |
|
|
If you are using the |
||||||||||
optional Filler or Backguard: |
|
|
optional Filler or Backguard: |
||||||||||
|
|
|
|
|
|
|
|
|
25 |
|
|
|
|
|
23-3/16 |
|
|
|
|
|
|
|
|||||
|
|
30 |
|
|
|
|
|
|
30 |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
||
|
|
|
|
|
|
|
|
|
|
|
|||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
All GE ranges are equipped with an Anti-Tip device. The installation of this device is an important, required step in the installation
of the range.
Note: Cabinets installed adjacent to slide-in electric ranges must have an adhesion spec of at least 194°F temperature rating.
Note: All 30" Slide-In Ranges conform to U.L. requirements for 0" spacing from range to adjacent walls below countertop. To reduce possibility of scorching the side walls above the countertop when no load is present on burners, it is recommended that a minimum 6" spacing from adjacent side wall be allowed for possible extended high-heat element operation.
Receptacle Locations: For all 30" Slide-In Ranges locally approved flexible service cord or conduit must be used because terminals are not accessible after range installation. See shaded area in drawing for location of electrical outlet box. Recommended outlet locations allow range to be installed directly against rear wall.
Optional Kits for Slide-In Electric Ranges (Available at additional costs)
Optional Top Filler Kits
JXS66WW – White
JXS66CC – Bisque
JXS66BB – Black
Accessory Backguards
(Attaches to the back of range as a backguard when unit is installed in
30" free-standing cutout) JXS39SS – Stainless JXS36WW – White JXS36CC – Bisque JXS36BB – Black
Body Sides
(Slide-in ranges are sold without sides installed. Can be installed on either left or right when unit has one exposed side [no cabinet adjacent].
Kit contains 1 body side) JXS76WW – White JXS76CC – Bisque JXS76BB – Black
Vertical Side Trim Kits
(If cabinet cutout width is more than 30", a vertical side trim kit may be used to close the gap between the range and cabinet) JXS86WW – White JXS86CC – Bisque JXS86BB – Black
Optional Lower Trim Kits
(If counter height is greater than 36.5", a lower trim kit is recommended to extend the useful height to 38" maximum)
JXS56WW – White
JXS56CC – Bisque
JXS56BB – Black
Installation Information: Before installing, consult installation instructions packed with product for current dimensional data.
|
Listed by |
|
Underwriters |
R |
Laboratories |
Specification Created 7/02
For answers to your Monogram,® GE Profile™ or GE appliance questions, visit our website at GEAppliances.com or call
GE Answer Center® service, 800.626.2000.
TM
JSP57BF/CF/WF – GE Profile™ 30" Slide-In Electric Range
H
1
<![if ! IE]><![endif]>2
H
6
Features and Benefits
•Convection Self-Cleaning Super Large Capacity Oven with Automatic Oven Door Lock
•Precise Air™ Convection System
•Convection Bake and Convection Roast
•Auto Recipe™ Conversion
•True Frameless Glass Oven Door with Big ClearView™ Window
•One 6", One Dual 6"/9" Element and Two 7" Ribbon Heating Elements with Bridge Element
•TrueTemp™ System
•SmartSet Electronic Oven Controls
•Certified Sabbath Mode
•3 Oven Shelves
•Custom Built-in Look with Simple Slide-In Installation
•Model JSP57WFWW – White on white
•Model JSP57CFCC – Bisque on bisque
•Model JSP57BFBB – Black on black
Specification Created 7/02