GE JP989WD, JP989BD, JP989CD, JP989TD Specification

TM

JP989WD/BD/CD/TD – GE Profile 30" Downdraft Electric Cooktop

Built-In Downdraft Cooktops Dimensions (in inches)

29-7/8

6

28-3/4

Cutout Dimensions (in inches)

20-5/8

28-7/8

25

1-7/8"

MIN. Required*

*U.L. Requirement.

Note: A 6" minimum spacing to adjacent side wall is required

Specification Revised 10/04

Cabinet Dimensions (in inches)

9

CL 4

16	10-1/2
	20

Receptacle Location

nstall an approved junction box within shaded area shown in diagram. Junction box must be at least 10-1/2" below top of cabinet.

KW Rating 240V 8.8

208V 6.7

Wall Installation

Wall installations require 25" countertop depth. When cabinet is flush against the wall, the fan housing can be rotated to the horizontal position for direct venting through rear wall. Make a

countertop cutout in the range cabinet according to unit dimensions and installation type. Duct hole is positioned in back of cabinet for through-the-wall ducting. Requires special offset adapter JXRW89.

Peninsula or Island Installation

For peninsula/islands a minimum 26" countertop depth is suggested. Blower should be in vertical position. Island or peninsula cabinets may require adjustment in cutout depth and/or location within the width dimensions. Duct hole is positioned in bottom of cabinet for island or peninsula installation.

Slab Installation

For peninsula or island installation and rear wall ducting, 6" PVC duct or locally approved piping should be used if installing under a poured concrete slab.

Installation Information: Before installing, consult installation instructions packed with product for current dimensional data.

Note: Electrical cable is not supplied with unit.

These cooktops are U.L. approved for indoor use only.

Listed by

Underwriters

Laboratories

For answers to your Monogram,® GE Profi le or GE® appliance questions, visit our website at ge.com or call GE Answer Center® service,

800.626.2000

220945

TM

JP989WD/BD/CD/TD – GE Profile 30" Downdraft Electric Cooktop

Venting Options

Inside Wall

Through Roof

Between the Floor Joists

Specification Revised 10/04

Direct to Outside Straight Duct

Downward Venting (in inches) Rear Wall Venting (in inches)

	6-1/8	9-1/8
		18-3/4
	10-1/8

Installing the Ductwork

Use galvanized or aluminum duct in 6" round or 3-1/4" x 10" size, or combination of both. PVC duct or locally approved piping should be used if installing under a poured concrete slab. Local building code must be followed in specifying type and schedule of all duct used.

	Listed by
	Underwriters
	Laboratories
	For answers to your Monogram,® GE Profi le or
Through the Cabinet Toe Space	GE® appliance questions, visit our website at
	ge.com or call GE Answer Center® service,
	800.626.2000

220945