TM
JP968BC/CC/SC/WC—GE Profile™ 36" Built-In CleanDesign Cooktop
Counter Installation (in inches) |
Cooktop Dimensions (in inches) |
13" MAX. depth
30" MIN. to unprotected cabinet
1-3/4" to rear wall
1-3/4" MIN. clearance to
side wall from cut-out
Electrical junction box 16" MIN. below countertop
36** 20-3/8**
Cooktop |
3-1/4* |
|
19-1/32 33-13/16
19-1/8
18" MIN. |
1-1/2" MIN. |
|
clearance to |
33-7/8 |
|
to cabinet |
side wall |
|
|
from cut-out |
|
2-1/2" Required
*Depth of unit at conduit location (rear) is 6-1/4"
**Stainless steel cooktop dimensions are 36-1/8" (width) and 21" (depth)
Cut should not interfere with cabinet structure at front
KW Rating
240V 9.6
208V 7.2
Breaker Size
40Amps†
†Note: Check local codes for required breaker size
Note: If installing with a GE Profile Performance™ or GE Profile™ Telescopic Downdraft System, consult both cooktop and downdraft installation instructions packed with product before installing. Cooktop gas/electric supply may need
to be re-routed to install downdraft.
Note: Consult cabinet and countertop manufacturer’s specs for flush mount installation prior to install.
Installation Information: Requires a 5" free area between the bottom of the
cooktop to any combustible material, i.e., shelving. Free area not required when installing wall oven underneath cooktop. Refer to installation instructions. Requires an 18" minimum from cooktop to adjacent overhead cabinets. Units are furnished with a 48" flexible armored cable.
Before installing, consult installation instructions packed with product for current
dimensional data. 36" Ribbon cooktops are approved for use over GE 30" Single Wall Ovens only. 30" Ribbon cooktops are approved for use over select GE 29" and GE 30" Single Wall Ovens. Refer to cooktop and wall oven installation instructions packed with product for current dimensional data.
Filler Trim Kit
When replacing an old GE 30" cooktop (with larger opening) with Models JP938/930/350/340, use the following one-piece trim kit to fill in the over-size hole. Available at additional cost.
JXTR31W (True White)
JXTR31B (Black glass with black, white or bisque pattern)
Flush Mount Installation Kit
Accommodates both 30" and 36" installations. Not for use with stainless steel models.
JXFLMTW (True white glass)
JXFLMBB (Black glass with black, white or bisque pattern)
|
For answers to your Monogram,® GE Profile™ or |
|
|
|
GE appliance questions, visit our website at |
|
Listed by |
|
WWW.GEAppliances.com or call |
|
|
Specification Created 3/01 |
|
Underwriters |
|
GE Answer Center® service, 800.626.2000. |
R |
Laboratories |
|
|
|