GE JN327X1WH, JN327X1CT, JN327X1AD Owner’s Manual

Use and Care of Recirculation Hood Model JN327
and Ventilating Hood Models JV327, JV337 & JV347

IMPORTANT SAFETY
INSTRUCTIONS

READ AND SAVE THESE
INSTRUCTIONS.

WARNING--TO REDUCE THE RISK

B. Installation work and electrical wiring must be

done bv qualified person(s) in accordance with

all applicable codes and standards, including

fire-rated construction.

C. When cutting or drilling into wall or ceiling,

do not damage electrical wiring and other

hidden utilities.

OF FIRE. ELECTRIC SHOCK OR
INJURY TO PERSONS, OBSERVE

THE FOLLOWING:

A. Use this unit only in the manner intended

by the manufacturer. If you have any questions.

contact the manufacturer.

B. Before servicing or cleaning unit. switch WARNING--To reduce the risk of fire,

power offat service panel and lock the service use only metal ductwork.

disconnecting means to prevent power from

being switched on accidentally When the service When using your hood...

disconnecting means cannot be locked, securely
fasten a prominent warning device, such as a settmgs. Boilover causes smoking and greasy

tag, to the service panel

CAUTION: For general ventilating use only. Do
not use to exhaust hazardous or explosive

materials and vapors.
When you get your new hood...

• Have it installed and properly grounded by a
qualified technician in accordance with the

installation instructions

• Have the installer show you the location of

the hood circuit breaker or fuse and mark it for

easy reference.

D. Ducted fans must always be vented to

the outdoors.

E. If this unit is to be installed over a tub or

shower, it must be marked as appropriate
for the application.

• Never leave surface units unattended at high

spillovers that may ignite and spread if hood is
used. Use surface umt heat settings recommended
by the manufacturer and adequate-size utensils.

• Never use your cooking appliance for warming
or heating the room. The electrical wiring of your

range hood may not withstand the resulting
excessive heat.

. Keep the hood clean and clean grease filter or

replace combination filter as recommended to
maintain good venting and to avoid grease fires.

WARNING--TO REDUCE THE RISK

OF A RANGE TOP GREASE FIRE:

• Take the time to read our suggestions for best use.

A. Keep fan. filters and grease laden

WARNING--TO REDUCE THE RISK surfaces clean

OF FIRE. ELECTRIC SHOCK OR
INJURY TO PERSONS, OBSERVE

B. Always turn hood ON when cooking

at high heat.

THE FOLLOWING:
A. The combustion airflowneededfor safe

operation of fuel-burning equipment may be

C. Use high range settings on range only

when necessary. Heat oil slowly on low
to medium setting.

affected by this unit s operation. Follow the

heating eqtupment manufacturer's guideline and

safety standards such as those published by the E. Alwavs use cookware and utensils appropriate

National Fire Protection Association (NFPA), for the type and amount of food being prepared.

and the American Society for Heating

Refrigeration and Air Conditioning Engineers • When flaming foods under the hood, turn the fan on.

_ASHRAE). and the local code authorities. ,co,n,,,ed _e.,_t;_,g_j

D. Don't leave range unattended when cooking.

Turn the page for Operation and Maintenance instructions.

GE Quality Product

If You Need Service...

IMPORTANT SAFETY
INSTRUCTIONS lcontmued_

WARNING--TO REDUCE THE RISK

OF INJURY TO PERSONS IN THE

EVENT OF A RANGE TOP GREASE

FIRE, OBSERVE THE FOLLOWING:

A. SMOTHER FLAMES with a close-fitting lid,

cookie sheet, or metal tray, then turn offthe burner.

BE CAREFUL TO PREVENT BURNS.

If the flames do not go out immediately,

EVACUATE AND CALL THE
FIRE DEPARTMENT.

B. NEVER PICK UP A FLAMING PAN

You may be burned.

C. DO NOT USE WATER. including wet dishcloths

or towels--a violent steam explosion will result.

D. USE AN EXTINGUISHER ONLY IF:

1. You know vou have a Class ABC extinguisher.
and you already know how to operate it.

2. The fire is small and contained in the area
where it started.

• Do not attempt to repair or replace any part of

your hood unless it is specifically recommended
in this book. All other servicing should be

referred to a qualified technician

• Disconnect hood circuit breaker or fuse before

performing any service.

Models: JN327 & JV347 non-ducted

I (ModeI JV347 has a lamp cover.)

////)Lamp

holder __

' Replaceable combination filter

Your hood is equipped with a replaceable combination
filter. When the fan is operated, air is drawn through the

filter and discharged into the room through the hood.
Model: JV327

Lamp
holder

3. The fire department is being called.

4. You can fight the fire with your back to an exit.

*Based on "Kitchen Firesafcty Tips" published by NFPA.

WARNING: The electrical wiring and fan

motor in this range hood are not intended

for use with, or provided with, a solid state
speed control. Any such alteration from
original factory wiring concept could result
in damage to the unit and/or create an
electrical safety hazard.

SAVE THESE

filter

Your hood is equipped with a metal grease filter. When
the fan is operated, air is drawn through the filter and

discharged to the outside.
Models: JV337 & JV347 ducted

(Model JV347 has a lamp cover.)

r

' Grease filter

Your hood is equipped with a metal grease filter. When
the tan is operated, air is drawn through the filter and

discharged to the outside.

CAUTION-before operating the hood:

• Install the lamp bulb (not provided). See the
Lamp Replacement instructions.

To Operate

F Vents (JN327 & JV347)

\

/_ I])i_ tt11!!!1155555!!!111

Fan switch Lamp switch

Lamp Switch Models: JN327, JV327, JV337

Press for OFF and ON.

Lamp Switch Model: JV347

Rotate clockwise, first position for NIGHT LIGHT,
second position for BRIGHT LIGHT.

Fan Switch

Models: JN327, JV327, JV337
CENTER position OFF, DOWN position LOW SPEED,

TOP position HIGH SPEED.
Model: JV347

Rotate Clockwise, FIRST position HIGH, SECOND

position MEDIUM, THIRD position LOW.

Grease Filter "JV" models only

The efficiency of your hood depends on a clean filter.
Frequency of cleaning depends on the type of cooking you

do. BUT GREASE FILTER SHOULD BE CLEANED
AT LEAST ONCE A MONTH. NEVER OPERATE

THE HOOD WITHOUT THE FILTER IN PLACE.
To remove: Pull down on the center of the front edge of

the filter. The filter will then slip out of the retaining tabs
on the back.

To clean: Soak and then agitate in a hot detergent
solution. Light brushing may be used to remove imbedded

soil. Rinse, shake and remove moisture before replacing.
With careful handling, the filter will last for years.

If replacement becomes necessary, order the part from
your dealer.

To replace: Slip the back edge of the filter into the
retaining tabs and push the front edge up until it snaps

into place.

Hood

Clean grease laden surfaces of the hood frequently.
Use warm detergent solution. About 1 tablespoon of

ammonia may be added to the water. TAKE CARE TO
NOT COME 1N CONTACT WITH FILTERS AND

OTHER NON-ENAMELED SURFACES. The hood
shell can be washed, rinsed and dried with a soft cloth.

To Maintain

Replaceable Filter

,IN327, JV347 non-ducted installation
The efficiency of your hood depends upon a clean filter,

the frequency of filter replacement depends upon the type
of cooking you do; however, with average, normal usage,

replacement should be every 6 to 12 months.

NEVER OPERATE THE HOOD WITHOUT THE

FILTER IN PLACE.

When to replace the filter: ,IN327

The filter has distinct color stripes of indicating material on
the visible surface. It is TIME TO CHANGE when the filter

stripes have either blended together or faded completely.
Model JV347 non-ducted installations

The filter supplied with the hood does not have
indicating stripes and should be replaced after 6 months.

Replacement filters will have the indicating stripes as
described under the filter for Model ,IN327.

To remove: Pull down on the center of the front edge of
the filter. The filter will then slip out of the retaining tabs

on the back.
To replace: Slip the back edge of the filter into the retaining

tabs and push the front edge up until it snaps in place.
Replace with genuine GE part: filter part number

WB02X8406.

CAUTION: Be certain when cleaning the hood
surfaces you do not touch the lamp bulb with moist

hands or cloth. A warm or hot lamp bulb may break
if touched with a moist surface. ALWAYS let lamp
cool COMPLETELY before cleaning around it.

Motor and Fan

To Clean Motor and Fan

1. DISCONNECT THE HOOD POWER SUPPLY AT

THE HOUSEHOLD DISTRIBUTION PANEL BY
REMOVING THE FUSE OR SWITCHING OFF

THE CIRCUIT BREAKER.

2. Remove the filter.

3. Wipe the tan blade and motor with cloth, dampened
only in ammonia and warm water solution.

4. Replace the filter.

5. Reconnect the hood power supply.

Installation Instructions for
General Electric Hood

WARNING---TO REDUCE THE RISK
OF FIRE, ELECTRIC SHOCK, OR

INJURY TO PERSONS. OBSERVE
THE FOLLOWING:

A. Installation work and electrical wiring

must be done by qualified persons(s) in
accordance with all applicable codes and

standards, including fire-rated construction.

B. When cutting or drilling into wall or ceiling, do

not damage electrical wiring

and other hidden utilities

C. Ducted fans must always be vented to the

outdoors.

WARNING---To reduce the risk of fire,
use only metal ductwork.

Important--Save for the local electrical
inspector's use.

JN327

JV327

Exhaust
Outlet

12"

Exhaust
Outlet

on underside of hood.

_pptyconnection box

5_"

17_"

bJ

pply connection box

on underside of hood.

I

5½"

17½"

JV337

,.....,_,Lt_ Power supply connection box

12" "'.-l,_ on underside of hood.

Exhaust Outlet Knockouts

Exhaust Outlet Knockouts

I'_ f 17YZ"

pply connection box

on underside of hood.

JV347