GE JKP15BABB Specification
Specification Revised 6/99
GE Appliances
JKP15BABB - GE 27" Single Wall Oven
2" x 4" or equiv.
runners
23-5/8 MIN.
25 MIN.
32-1/2
27-1/2" MIN.
10
27
20" MIN.
door opening
allowance
Allow 3/4"
for overlap
over all edges
of cutout
Locate
junction box
either 5" MIN.
below cutout
floor or 34"
MIN. above
cutout floor.
Recommended
cutout location
from floor
(Minimum 15-5/8"
from floor when
installed below built-in
microwave oven)
29-1/8
26-5/8
23-5/8
Installation Information: Before installing, consult installation
instructions [Pub. No. 31-10200] packed with product for current
dimensional data.
Dimensions (in inches)
Cut Opening
in Solid
Bottom
10
Note: If a solid
bottom is used
instead of the
runners, a 6" x 10"
rectangle must be
cut out of the
bottom for optimum
performance
and proper air
circulation.
6
6
R
Listed by
Underwriters
Laboratories
Note: Cabinets installed adjacent to wall ovens must have an
adhesion spec of at least 194°
For answers to your Monogram,
®
GE Profile Performance Series,
™
GE Profile™or GE appliance questions, call
GE Answer Center®service, 800.626.2000.
KW Rating
240V 3.4
208V 2.6
Breaker Size
20 Amps
†
†
Note: Check local codes for required breaker size
Specification Revised 6/99
GE Appliances
JKP15BABB - GE 27" Single Wall Oven
24-1/4"
MAX.
Locate thermal oven junction
box either 5" MIN. below
cutout floor or
approximately 54"
MIN. abo ve
cutout floor.
For Microwave:
Locate 120V, 60
cycle grounded
power receptacle
within shaded
area.
Note A:
21" MIN.
receptacle in
cabinet.
19" MIN.
receptacle
outside cabinet.
17-5/8"
MAX.
23-5/8"
MIN.
15-5/8"
MIN.
Lower Oven
Opening.
3/8" Thick
Shelf
Microwave Opening
2-1/4
27
A
Microwave
oven should be
installed on a
3/8" plywood
base and
supported by
2"x4" or 1"x4"
equivalent
runners on all
sides. Base
must be
capable of
supporting a
minimum of
100 lbs.
26-5/8
19-3/4
29-1/4
*27-5/8" MIN.
28-1/8" MAX.
*Allow 3/4" for overlap over all edges of built-in oven cutout.
25' MIN.*
Note: Recommend approximately 1/4" gap between microwave trim and
wall oven trim. (The 2-1/4" dimension should create a 1/4" gap.) Allow
1-1/2" for overlap of the Microwave Oven Kit Trim over all edges of the
trim kit cutout.
Installation Information: Before installing, consult installation
instructions packed with accessory trim kit, microwave oven and single
oven for current dimensional data.
Dimensions (in inches)
For answers to your Monogram,
®
GE Profile Performance Series,
™
GE Profile™or GE appliance questions, call
GE Answer Center®service, 800.626.2000.
R
Listed by
Underwriters
Laboratories
Loading...