GE JK915BF, JK915CF, JK915WF Specification
JK915BF/CF/WF
R
C
L
(Must Support 275 LBS.)
2 x 4 or
equivalent
runners
Suitable
bracing
to support
runners
18"
over centerline
of cabinet
2" x 4"
or equiv.
runners
B MIN.
C MIN.
Conduit 48-1/2" long
6015 Built-in Single Oven
(Pub. 1-G003 pg. 107) April 28, 1993
32-1/2
D
10
A
Allow 3/4"
for overlap
over all edges
of cutout
Locate
junction
box
either
5" MIN.
below
cutout
floor or
34" MIN.
above
cutout
floor
Minimum
cutout
location
from
floor
(Minimum 15-5/8"
from floor when
installed below built-in
microwave oven)
E
G
F
20
GE Profile™ 27" Built-In Single Oven
Dimensions and Installation Information
KW Rating
240V
208V
3.4
2.6
Cabinet 27"
Breaker Size
240V
208V
20 Amps
20 Amps
Note: These ovens are not
approved for stackable or
side-by-side installations.
These ovens can be installed
side-by-side with no less
than 30” distance between
center-to-center of each oven.
Note: Cabinets installed adjacent to wall ovens must have an adhesion spec
of at least a 194°F temperature rating. For 27” built-in single ovens, if marks,
blemishes or the cutout opening is visible above the installed oven, it may
be necessary to add wood shims under the runners and front trim until
the marks or openings are covered. Electric wall ovens are not approved
for installation with a plug and receptacle. They must be hard wired in
accordance with installation instructions.
Installation Information: Before installing, consult installation instructions
packed with product for current dimensional data.
For answers to your Monogram,® GE Profile™ or
GE® appliance questions, visit our website at
ge.com or call GE Answer Center® service,
800.626.2000.
A - Cabinet Width Required 27" min.
B - Minimum Cabinet Depth 23-5/8"
C - Opening Width 25" min. - 25-1/4"
D - Opening Height 27-5/8" min. - 28-1/8" max.
Oven
E - Overall Depth 23-5/8"
w/o trim 28-1/4"
F - Overall Height with trim 29"
G - Overall Width 26-5/8"
Dimension and installation information are shown in inches.
Listed by
Underwriters
Laboratories
Specification Revised 1/05
220354
R
JK915BF/CF/WF
90° Street el
45° Elbow
Cabinet sides
2" Diameter hole (20-7/8"
from front of countertop
to hole center)
(Pub. 1-G003 pg. 107) May 11, 1993
5" To center of 2" diameter
hole from countertop
90° Street el
45
° Elbow
To center of 2" diameter
hole from countertop
Cabinet sides
3-7/16"
2" MIN. diameter hole
(23-1/4" from front
surface of countertop)
25
Gas or electric cooktops may be
installed over this oven. See cooktop
installation instructions for cutout size.
See label on top of oven for approved
cooktop models.
Gas or electric connections
for gas cooktop must be
located in an adjacent
accessible location to the right
5
240V / 208V
Junction Box
Location
36"
Typical
Countertop
Height
24
Allow 1"
unit overlap
all edges
25" MIN.
25 1/4" MAX.
27 5/8" MIN.
28 1/8" MAX.
3/4" Support
Platform Required
Must Support 150 Lbs.
22" MIN.
Above
Support
Platform
GE Profile™ 27" Built-In Single Oven
Undercounter Dimensions and Installation Information
Note: Oven is rated for use only under 30”
standard or sealed burner gas and selected
30” CleanDesign and Calrod® electric cooktops.
Cabinets installed adjacent to wall ovens must
have an adhesion spec of at least a 194°F
temperature rating.
Electric wall ovens are not approved for
installation with a plug and receptacle.
They must be hard wired in accordance
with installation instructions.
Installation Information: Before installing,
consult installation instructions packed with
product for current dimensional data.
Sealed Burner Gas Cooktop
Standard Burner Gas Cooktop
For answers to your Monogram,® GE Profile™ or
GE® appliance questions, visit our website at
ge.com or call GE Answer Center® service,
800.626.2000.
Dimension and installation information are shown in inches.
Listed by
Underwriters
Laboratories
Specification Revised 1/05
220354
Loading...