HLD4000
4"
6"
5"
5"
4"
Figure A
Floor MUST be Even
With Room Floor
Cabinets
Square
and
Plumb
This Wall Area
must be Free
of Pipes or
wires
24"
Min.
24"
Min.
34-1/2"1/4"
Underside of
Countertop
to Floor
Plumbing and Electric Service
Must Enter Inside This Area
24
25
MAX.
20-1/2
4
4 (Adjustable)
33-3/4" MIN.
adj. to 35"
27-1/2
22
B
See Detail E for 3/4" Panel
Detail E for 3/4 panel only
Door insert
A
Back ViewFront View
F
F
1-7/8 1-7/8
20
Section E-F
C
3/8
3/4
Detail E for 3/4 panel only
Back ViewFront View
F
F
1-7/8 1-7/8
20
Section E-F
C
3/8
3/4
HLD4000/40N – Hotpoint Built-In Dishwasher
Dishwasher Dimensions (in inches)
Electrical Rating
Voltage AC............................................... 120
Hertz........................................................ 60
Total connected load amperage............. 10
Calrod® heater watts max................... 875
For use on adequately wired 120-volt, 15-amp circuit
having 2-wire service with a separate ground wire.
This appliance must be grounded for safe operation.
Specification Created 9/06
450151
Panel
Kit A B C
GPF525 25-1/4" 23-1/2" N/A 1/4"
GPF575 25-1/2" 23-5/8" 1/4" 3/4"
Thick ness
Note: The rough cabinet opening must be at least
24" deep, 24" wide and approximately 34-1/2"
high from floor to underside of the countertop.
Dishwasher must not be installed more than 10
feet from sink for proper drainage. All plumbing
and electrical work must be in accordance with
local codes. The power cord and connections must
comply with the National Electrical Code Section
422 and/or local codes and ordinances. The cord
must be no longer than 6 ft. from the junction box to
the receptacle.
Installation Information: Before installing, consult
installation instructions packed with product for
current dimensional data.
As an ENERGY STAR®
partner, GE has determined
that this product meets the
ENERGY STAR
for energy efficiency.
guidelines
Listed by
Underwriters
Laboratories
Loading...