GE GS Installation Guide
GE
Installation Guide
Lighting
LuminationTM LED Luminaires
(GS14 Series)
BEFORE YOU BEGIN
Read these instructions completely and carefully.
WARNING/AVERTISSEMENT
RISK OF ELECTRIC SHOCK
• Turn power off before inspection, installation or removal.
• Properly ground electrical enclosure.
RISK OF FIRE
• Follow all NEC and local codes.
• Use only UL or IEC approved wire for input/output connections.
Minimum size 18 AWG (0.75mm2).
• Do not install insulation within 3 inches (76 mm) of luminaire top.
RISQUES DE DÉCHARGES ÉLECTRIQUES
• Coupez l’alimentation avant d’’inspecter, installer ou déplacer le luminaire.
• Assurez-vous de correctement mettre à la terre le boîtier d’alimentation électrique.
RISQUES D’INCENDIE
• Respectez tous les codes NEC et codes locaux.
• N’utilisez que des ls approuvés par UL ou IEC pour les entrées/sorties de
connexion. Taille minimum 18 AWG (0.75mm2).
• Maintenir une distance de 76 mm (3 pouces) entre le luminaire et l’isolant.
Save These Instructions
Use only in the manner intended by the manufacturer. If you have any questions, contact the manufacturer.
Prepare Electrical Wiring
Electrical Requirements
• The LED luminaire must be connected to the mains supply according to its ratings on the product label.
Grounding Instructions
• The grounding and bonding of the overall system shall be done in accordance to local electric code of the country
where the luminaire is installed.
imagination at work
Components Included
Housing base (1)
1
Lens (1)
2
Geartray including T8 sockets (1)
3
Ground screw (1)
4
Geartray clips (2)
5
Lanyard (2)
6
Housing latches (2)
7
LED diver (1)
8
LED T8 tubes (2)
9
Mounting brackets (2)
10
Endplugs (2)
11
Installation
10
1
11
7
8
5
4
6
3
9
2
Chain and “S” hook
Mount the wrap-around brackets on the ceiling or support rail using appropriate hardware. After brackets are
1
secured in place, install one side of the housing in the bracket, then rotate up and snap the other side of the
housing into bracket. Chain and “S” hook (not included) can also be used to support the brackets
Unfasten the 6 latches and remove the lens.
2
Remove the LED T8 tubes (optional).
3
Loading...