GE GP94ENSRSA01, GP94DNSRSA01, GN94ENSRSA01, GN94DNSRSA01, GN75ENSRSA01 Owner’s Manual

IMPORTANTSAFETYINFORMATION.
READALL INSTRUCTIONSBEFOREUSING.

INSTALLER: Leave this manual with the
appliance.

CONSUMER: Retain this manual for future
reference.

WARNING: iftheinformation

in this manual is not followed exactly,
a fire or explosion may result causing
property damage, personal injury

or death.

-- Do not store or use gasoline or other
flammable vapors and liquids in the

vicinitg of this or ang other appliance.

- WHAT TODO IF YOU

SMELL GAS

[] Do not trg to light a match, or cigarette,

or turn on ang gas or electrical appliance.

[]Do not touch ang electrical switch;

do not use ang phone in gour building.

[] Clear the room, building or area of all

occupants.

[] Immediatelg call gout gas supplier from

a neighbor's phone. Follow the gas
supplier's instructions carefullg.

ANSI Z21103 • CSA 43

] lf gou cannot reach gour gas supplier,

call the fire department.

-- Installation and service must be
performed bg a qualified installer,

service agencg or the gas supplier.

WARNING! or oursafety,

the information in this manual must be followed to
minimize the risk of fire or explosion, electric shock,

or to prevent propertg domoge, personol injurg or
loss of life.

Error codes, ge.com

Thiswater heater hasthe abilitgto check its own operation
continuouslg. If a fault occurs,an error code will flash on the

displag of the remote control onlg when the water isrunning.
Thisassistswith diagnosing the fault, and mag enable gou to

overcome a problem without a servicecall. Pleaseidentifg the
code displaged when inquiring about service.

Error Code Table

WARNING: Some of the checks below mag

need to be done bg a qualified service technician.

02 No burner operation during freeze •

protection mode

10 Air supplg or exhaust blockage •

11 No ignition •

12 Flame failure •

14 Thermal fuse

16 Over temperature warning

32-72

LC(001 Scale buildup in heat exchanger
No code Nothing happens when water flow is activated

Checkthat the gas isturned on at the water heater,gas meter or cglindeE

Ifthesgstem is propane, make sure gas is inthe tank.

Callfor service.

EnsureGE-approved venting materials are being used.
Checkthat nothing is blocking the flue inlet or exhaust.
Checkall vent components for proper connections.
Checkthat the gas isturned on at the water heater,gas meter or cglindeE

Ifthesgstem is propane, make sure gas is inthe tank.

Ensureappliance is properlg grounded.
Checkthat the gas isturned on at the water heater,gas meter or cglindeE

Checkfor obstructions in the flue outlet. If the sgstem ispropane, make sure
gas is in the tank.

Ensureappliance is properlg grounded.
Callfor service.

Checkfor restrictions in air flow around unit and vent outlet.
Checkfor foreign materials in exhaust piping.

Callfor service.

Seepage 11 for Flushing Procedures.
Clean inletwater supplg filtec
On new installations, ensure hot and cold water linesare not reversed.

Ensuregou have at least the minimum flow rate required to firethe unit.

9