GE DPXH46EACC, DPXH46EAWW Specification
DPXH46EACC/WW—GE Extra-Large 5.7 Cu. Ft. Capacity Front-Load Dryer
Specification Revised 1/01
TM
Dryer Dimensions (in inches)
Exhaust Options:
Electric—4-way via rear, right, left and bottom.
Circuit Requirements:
Electric—An individual, properly-grounded branch circuit, protected by a 30-amp circuit
breaker or a time-delay fuse, is required.
Electric Dryer Rating:
120/240V, 3-wire, 5600W, 24A
120/208V, 3-wire, 4400W, 22A
Note: Dryer wall outlet must be located within 36" of service cord entry and accessible
when dryer is mounted in position.
Installation Information: For complete information, see installation instructions packed
with your dryer.
REAR VIEW
26-7/8
3-3/4
1
36
Under
Counter
34-5/8"
3/16"
Gas Pipe Connection
Electric
Connection
2-9/16
13-9/16
SIDE VIEW
25-3/4
47-1/2
4-3/4
Optional
Vent Knockout
Door Open
90°
4-3/8
3/4
For answers to your Monogram,
®
GE Profile Performance Series,
™
GE Profile™or GE appliance questions, call
GE Answer Center®service, 800.626.2000.
R
Listed by
Underwriters
Laboratories
DPXH46EACC/WW—GE Extra-Large 5.7 Cu. Ft. Capacity Front-Load Dryer
Specification Revised 1/01
TM
Undercounter Installation
• Accessory mounting kits are required for
undercounter installation. To order,
call 1-800-848-7722.
Washer—Order Pub. No. 14-A037
Dryer—Order Pub. No. 14-A008
Stacked Installation
• Brackets for stacking dryer over washer
are included with the dryer.
Alcove or Closet Installation
• If your dryer is approved for installation
in an alcove or closet, it will be stated
on a label on the dryer back.
• The dryer MUST be exhausted to the
outdoors.
• Minimum clearances between dryer
cabinet and adjacent walls or other
surfaces are:
0" either side
3" front and rear
• Minimum vertical space from floor to
overhead cabinets, ceilings, etc. is 52".
• Closet doors must be louvered or
otherwise ventilated and must contain
a minimum of 60 sq. in. of open area
equally distributed. If this closet contains
both a washer and a dryer, doors must
contain a minimum of 120 sq. in. of
open area equally distributed.
• The closet should be vented to the
outdoors to prevent gas pocketing in
case of a gas leak in the supply line.
• No other fuel-burning appliance shall be
installed in the same closet with the dryer.
Bathroom or Bedroom Installation
• The dryer MUST be exhausted to the
outdoors.
• The installation must conform with the
local codes, or in the absence of local
codes, with the National Fuel Gas Code,
ANSI Z223.
Minimum Clearances other than Alcove
or Closet Installations
• Minimum clearances to combustible
surfaces:
0" both sides
3" rear
36"
25-3/4"
53-1/2"
Washer
Top Sheet
Dryer
Top Sheet
Countertop
14''
29''
56''-60''
Lip on All Sides
3/4" High x 3/4" Wide
Max.
70-5/8"
25-3/4"
26-3/4"
Free-Standing Installation
Undercounter Installation
Raised/Built-In Installation
Stacked Installation
For more information on venting kits and
accessories, please call 1-800-GE-CARES.
Special Installation Requirements
For answers to your Monogram,
®
GE Profile Performance Series,
™
GE Profile™or GE appliance questions, call
GE Answer Center®service, 800.626.2000.
R
Listed by
Underwriters
Laboratories
Loading...