GE DDG7188V, DDE7108V Operation Instructions

Thisleaflet contains specific
7q23
operating information for your
model.
Save this leaflet with the Use and Care Bookwhich also came with your dryer.
~0~ BE~~ READ AND BECOME FAMILIAR WITH BOTH.
Opera~ingInstructions
foryour dryer
RESUL;S,
—~
k
L
DEIICATES
KNITS
FLUFF
Pust+
0
n
n
LOW H EAT
NO HEAT
.
TO START
LoadYour
Dryer
~Clean the lint filter each time the dryer is used. Always be sure the lint filter is in place. Don’t use the dryer without it.
IIZIGood sorting for the dryer begins at the washer. Generally, if clothes are sorted right fo~_w-ashing,they:Le.
sorted right for drying. See your Use and Care Book for sorting help. (If you do mix various types of fabrics in your load, set the controls for the
lighter-weight fabrics and remove when dry. Reset controls for remaining heavier fabrics.)
Properly.
HEAVY DUTY DRYER
WITH AUTOMATIC DRY CONTROL
. L.–. . ------ . .. . ---- _
—.. —————..4 !.
~
OFF#
!
TIMED CYCLE
B
setthe Controls.
See the Controls Setting Guide below.
Fabric Care Selections
Pusha button to select the proper heat for your load.
ShoukibeusedvvithCyCkS indicated~
Fabric Care Selections
——.
“Cottons- -“-
HighHeat PennPress
MediumHeat Delicates/Kriits
LowHeat
Fluff
I
NOHeat
...-
Automatic Regular Cycle
“-- ~
I
I
TurnCycle Selector to desired
Automatic
Perm Press and Knits Cycle
e
e
I
(Openingthe door during operation
cycle setting. stops the dryer. To re-start, close the
Press PUSHTO STARTbutton to
door and press the STARTbutton.)
start dryer.
a
Timed Cycle
e
*
e
163
1-
..
Cmtrds settingGuide
AutomaticPerrnPress& KnitsCycle
Fabric
FabricCare
Selection’ (Medium Heat)
Cycle
Selector Medium
Setting
*The terms High, Medium and Low Heat are those usually found on fabric care labels, For best results, follow your fabric care label instructions.
*’Lighl: For lightweight fabric loads; Medium: for,most normal loads; Heavy Fabrics: for loads that include heavyweight fabrics and for very
small loads,
NO’TE:The Cycle Selector settings indicated above are to be used as a guide. You may find that best results are obtained for some of your fabrics by setting the Cycle Selector to either side of the recommended setting.
Permanent Press or Cotton/ Synthetic Blends
Perm. Press Delicates/Knits Cottons Cottons
Synthetic Knits or of Mixed Delicates
(Low Heat) Light
Fabrics
TimedCycle
Avg. Load Cottons
(High Heat) (High Heat) (Medium Heat)
45 Min.
Cottons Perm. Press to Cottons & Linens (Damp Dried be De-Wrinkled for Ironing)
20 Min. 10Min.
without Washing Machine Dry—High Heat.) Perm. Press Fluff Cottons
No Heat Fluff
(No Heat)
Time
Desired
GENE RAL@ELECTBIC
AutomaticReguiarCycle
(Those articles labeled
(High Heat) Light, Medium or
Heavy Fabrics depending on load**
1’-7
Polyesterkms & “~,
permanentpressdryin~’:tips
* DO NOTOVERLOAD—Garments being dried or dewrinkled should tumble freely.
* REMOVECLOTHESlMMEDIATELY—
Tohelp prevent wrinkling, remove from the dryer immediately at the end of the drying cycles.
@PLACEON HANGERS—Permanent Pressand Polyester knit garments look best if placed on hangers after
drying.
Models
DDE7108V–eiectric DDG7188V–gas
whath the difference
betweenAutomatic&
Timed drying?
AtdkxrnaticDrying
When using the AUTOMATICcycles, the Automatic Dry Control system continually senses the temperature of the air in the dryer drum. Wet laundry keepsthis air cool. Whenthe laundry is dry enough (and the drum air warm
enough)the heat turns off. When the air cools, the heat turns back on. This off and on cycling may happena num­ber of times (dependingon the fabric, load size, and Cycle Selector setting.)
The Cycle Selector advances (when
the heat is off) until it automatically turns off dryer.
,,
Timed !DrykIg
When using the TIMED CYCLES,you
select the number of minutes you wish the dryer to run and it turns off at the end of this time period.
Part N). 141A7400 PI14 Pub. No. 49-9423
I
I
General Electric Company
Appliance Park
Louisville, Kentucky 40225
Loading...