GE DDC4400SNMWH, DDC4400SMMWH, DDC4400SLMWH, DDC4400SKMWH Owner’s Manual

Contents
Care and Cleaning 5 D_'er Exhaust 5
Lint Filter 5 Model and Serial Numbers 6
IUse and Care Guide I
CommercialDryer
Salety Instructions 2--4 Service 6
Storing Dryer 5 Warrant, 6
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE
FOR GAS DRYERS: YOU MUST POST IN A PROMINENT LOCATION
Instructions to follow if the user smells gas:
Contact your local gas supplier for information to be displayed.
,
Instructions concerning flammable materials
as follows:
FOR YOUR SAFETY Do not store or use gasoline or other
flammable vapors and liquids in the vicinity of this or any other appliance.
IMPORTANT SAFETY INSTRUCTIONS
Read all instructions before using this appliance.
IMPORTANT SAFETY NOTICE
A Warning--To reduce the risk of fire,
electric shock, or injury to persons
when using your appliance, follow basic precautions, including the following:
tttml
The California Safe Drinking Water and Toxic Enforcelnent Act requires the Governor of
California to publish a list of substances known to the slate to cause cancer, birth defects or other
reproductive harm and requires businesses to warn customers of potential exposure to such substances.
Gas appliances can cause minor exposure to four of these substances, namely benzene, carbon
monoxide, formaldehyde and soot, caused primaMy by the incomplete combustion of natural
gas or LP thels. Exposure to these substances can be minimized
further by properly venting the dryers to the
ot,,tdoors.
Basic Precautions
Use this appliance only for its intended purpose
as described in this Use and Care Guide.
This dryer must be properly installed and located in accordance with the Installation
Instructions before it is used. If you did not
receive an Installation Instruction sheet with your dryer, you can obtain one by contacting the service
location nearest you.
o lmeate where the temperature is above 50°F.
(10°C.) for satisfactory operation of the dryer control system. Do not install or store the dryer where it will be exposed to the weather.
Connect to a properly rated, protected and
sized power supply circuit to avoid electrical overload.
Exhausting to the outside is REQUIRED to
prevent large amounts of moistuiv and lint from being blown into the room. Carefully follow the
E'*,hausting Details in the Installation Instructions.
Do not repair or replace any part of the appliance or attempt any servicing unless
specifically recommended in this Use and Care Guide or in published user-repair instructions
that you understand and have the skills to
carry out.
Clean the lint filter before each load to prevent lint accumulation inside the dryer or in the
room. DO NOT OPERATE THE DRYER WITHOUT THE LINT FILTER 1N PLACE.
In fldfilling the specific needs of different
commercial installations the purchaser of this dryer may wish to locate the coin box and controls
in anyof a number of locations. The responsibility for the proper perflJrmance of this work lies solely
with the purchaser. Itshould be done by properly trained and qualified personnel, and in accordance with local code requirements.
To Reduce the Risk of Electric Shock
Properly ground to conform with all governing
codes and ordinances. Follow details in Installation Instructions.
When disconnecting this appliance pull by the plug rather than the cord to avoid damage to the
cord orjunction of cord and plug. Make sure that the cord is located so that it wil! not be stepped on,
tripped over or otherwise subjected to damage or stress.
To minimize the possibility of electric shock, unplug this appliance from the power supply
before attempting any maintenance or cleaning (except the removal and cleaning of the lint filter).
NOTE: Appliance MUST be unplugged to ensure that power is disconnected. Turning the appliance
off at the control panel does NOT disconnect power.
Do not tamper with the controls.
Do not operate this appliance if it is damaged, malfunctioning, partially disassembled, or has
missing or broken parts, including a damaged
cord or plug.
Any coin box or similar device added to the dryer,
either electrically or mechanically, should be properly grounded.
Loading...
+ 4 hidden pages