GE Backsplash Kit Installation Instructions

Installation Instructions

Backsplash

Move Anti-Tip Bracket

Backsplash Kit

Parts Supplied:

Backsplash Assembly 5 Screws

1 Spacer

Tools Required:

#2 Phillips screw driver

1/4” Hex head Driver

Installing the Kit

The purpose of the backsplash kit is to fill the gap between the back of the range and the wall, when the countertop opening is cut to a 25” depth. NOTE: This kit supplies a spacer that is used when a body side kit is used in conjuction with this kit. Keep this part for that type of application.

Attach the backsplash assembly to the rear of the range prior to installing the range in the

countertop opening. Attach the assembly to rear of the range to the five holes above the louvers using the 5 screws

located in the pack. See Figure 1

If the backsplash is being attached to a Drop-In range, the anti-tip bracket must be moved to

position 5 and proper attachments to the wall must be made to assure that the anti-tip bracket engages below the attachment. The attachment must be able to withstand 200 lbs of force at the engagement point. Refer to the Figure 2 below.

Refer to the range Installation Instructions to place the range in the countertop opening and

perform all tests required.

Anti-Tip Bracket Location

( Rear of Range )

1 2 3

Cook Top

Backsplash

5-Screws Supplied (2 - each end 1 - in the middle)

Glass Cooktop

Wire Cover

Fig. 1

Pub. No. 31-10452

Move Anti-Tip Bracket (See Fig. 2)

Drop-In Only

BACKSPLASH ANTI -TIP INSTALLATION

Glass Maintop

Attachment

Position #5 NonKit Applications

Anti-Tip Bracket

Attachment To Engage Bracket By 1/2"

DROP - IN ONLY

Interior Wall

Backsplash

Wall Stud

Countertop Surface

10 - 3/8"

Wire

Cover

1-1/2"

Attachment Anchored to Wall Stud Is Recommended

Move Anti-Tip bracket from Position 1

(as supplied)

to Position 5

Fig. 2

229C4053P426