Mini Wireless Optical Mouse
Instruction Manual
98793 - green
98796 - blue
98794 - pink
For technical support contact Jasco Products at
1-800-654-84 83 or ww w.jasco pr od ucts.co m.
Page 2
TABLE OF CONTENTS
1. PACKAGE CONTENTS----------------------4
2. SYSTEM REQUI R EME N TS ----------------4
3. SPECI AL MOUSE FUNCTIONS ----------4
4. BATTERY I N STALLATION----------------5
5. HARDWARE INSTALLATION------------6
6. TROUBLE SHOOTING ----------------------8
7. FIVE YEA R LIMI T ED W ARRA NT Y----9
8. FCC STATEMENT--------------------------- 10
Page 3
1. Package Contents
• Mini Wireless Optical Mous e • 2 AAA Batteries
• Mini Instruction Manual • Mini USB Receiver
2. Syste m R equirements
• Windows® 98 SE or higher
• Mac OSX 10.1 or hi gher
• Available USB Port
3. Special Mouse Functions
• The mou se will go to slee p when idle fo r a long period o f
time to sav e batter ies. The mo use au tomatically wakes upon
movement.
• When the Low Battery LED (located on the receiver)
changes from green t o red, change the bat teries.
Page 4
4. Battery Installation
Battery Compartment Cover
PUSH
HERE
PUSH
HERE
Replacin g batteries in your GE mini mouse is easy!
1) Simply grip the sides of the mouse and slide the battery cover
back.
2) Replace the old batteries with two AAA batt er ies
3) Replace the battery cover.
Page 5
Page 6
5. Hardware Installation
Please keep these di r ections in a safe pl ace.
1) Insert the enclosed batteries into the battery compartment of
your mouse fol lowing the dir e ctions in Section 4.
2) Plug the Optical Mini Mouse receiver into an available USB
port on your computer or USB hub. It is not necessary to
reboot your com puter.
3) If prompted, insert your Windows disk and follow the on
screen instructions. (This step is not necessary for all
operating systems. Your system will prompt you if it is
necessary.)
4) The mouse should auto link requiring no further installation
procedure.
5) In case the auto link feature does not occur, you must
manually link your mouse to your receiver.
6) Press the link button on your receiver.
7) Press the link button on the bottom of your mouse.
8) Your mouse should now function normally. Move your
mouse to test functionality.
Page 7
6. Trouble Shooting
• The Mini Optical Mouse does not work properly
Optical mice do not work well on glass or highly reflective
surfaces. If this applies to you, try using your mouse on a
differ ent surface.
Re-link your mouse. Press the link button on the receiver.
Press the link button on the bottom of your mouse.
Change the batteries on your mouse. See secti on 4.
• Mouse will not move
Re-link your mouse. See section 5.
Sometimes screen savers interfere with the wake feature.
Turn off your screen saver. If the mouse works, try using a
differ ent screen saver.
Change the batteries on your mous e. See section 4.
Page 8
7. Five Year Limited Warranty
Jasco Products Company warrants this product to be free from
manufacturing defects for a period of five years from the original
date of c onsumer purchase. This wa rranty is limited to the re pair
or replacement of this product only and does not extend to
consequential or incidental damage to other products that may be
used with th is unit. Th is warran ty is in lie u o f all o th er wa rra n tie s
expres s or implie d. Som e state s do no t allow limitatio ns on h ow
long an implied warranty lasts or permit the exclusion or limitation
of incide ntal or consequentia l damages, so the above limitations
may not apply to you. This warranty gives you specific rights, and
you may also have other rights which vary from state to state. If
unit should prove defective within the warranty period, return
prepaid with dated proof of purchase to:
Jasco Product s Company
10 East Memor ial Dr
Oklahoma City, OK 73114
Page 9
8. FCC Statement
Notice: Federal Communications Commission (FCC)
requirements, Part 15
This equipment has been tested and found to comply with the
limits for a c lass B d igital dev ice, pu rsuant to part 15 of the FCC
Rules. The se limits are de signed to provide reasona ble protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interfer ence to radio communications. How ever,
there is n o gu a ra n te e th a t in ter fe re nce w ill n o t o cc u r in a p ar ticu la r
installation . If this equip ment does c ause harmful inte rference to
radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
Page 10
• Reorient or relocate the recei ving antenna.
• Increase the separation between t he equipment and r eceiver .
• Connec t the equipment into an o utlet on a circuit differen t
from that to whi ch the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for
help.
CAUTION: Any changes of modifications not expressly approved
by the grantee of this device could void the users authority to
operate the equipment. This de vice complie s with Part 15 of th e
FCC Rules. Ope ration is su bject to the f ollowing two condition s:
(1) this de vice may not ca use harmful interference, an d (2) this
device must accept any interference received, including
interference that may cause undesi red operati on.
is a trademark of the
General Electric Company
and is used under license to
Jasco Prod ucts Company LLC,
10 E. Memorial Rd.,
Oklahoma City, OK 73114.
www.jascoproducts.com
Page 11
Loading...