Fluo re sc en t
-12“ CLOiiil' UcjjJ-J
Batt er y Op era te d
•Add safety and security to any room
•
Ideal for cupboards, closets, attics, basements,
storage sheds and garages
•
Reguires 8 AA"batteries
•For indoor use only
INSTALLING BAHERIES:
Slide battery cap off end of light and install 8 "AA", 1.5 volt
batteries (not included) with polarity as shown on diagram
on the fixture. Replace cap. IMPORTANT: Different types of
batteries or new and used batteries should not be mixed.
Exhausted batteries should be removed from the fixture
and disposed of properly.
MOUNTING:
Your closet light can be mounted
using the supplied adhesive-back
"hook and loop" mounting strips.
Note: "Hook and loop" strips
should only be used on clean,
dry, and smooth surfaces. Do
not use on unfinished wood or
rough surfaces.
1. Separate the supplied "hook
and loop" mounting strips
from each other, placing
the "hook" and "loop" sides
of the strips into two piles.
2. Clean and dry surface before
mounting. Peel back paper
1 »• »'
• O
»* «** *
t I*.*
and apply "loop" mounting
strips to both ends and middle
of the back of the closet light
3. Apply the "hook" strips to
the desired mounting location,
making sure they are the
same distance a part as
those on the closet light
4. Press the closet light onto
the mounting surface.
NOTE: Allow one day for the adhesive backing to set before
attempting to pull closet light away from mounting surface.
Light can also be mounted using supplied screws.
TUBE REPLACEMENT:
1. Remove end caps from light
2. Remove transparent lens cover.
3. Twist the tube slightly in either direction to remove.
4. Replace with 8-watt, 12" T5 bulb.
5. Replace tube cover and end caps.
CAUTION:
Do not turn on light with tube disconnected to avoid possible
damage to solid state circuit
imm-
<r
/—
1\ r
■ -* ' '
[J
A
Batteries may leak harmful liquids
or ignitable materials or explode
causing injury or product damage
• Do not mix old and new or other
WARNING
]
—
battery types
• Replace all batteries atthesame
time
• Replace fully discharged batteries
immediately