GE 19211, 19210 User Manual

GE Model 19210/19211

www.jascoproducts.com

Wireless Pushbutton

Required Tools: Small flat blade screwdriver, drill, drill bit, and phillips screwdriver.
Included Hardware:

(2) 3x20mm screws
(2) Double sided adhesive pads

Required Tools: Small flat blade screwdriver, drill, drill bit, and phillips screwdriver.

Chime Tune Setting

All wireless chimes may have more than one push button. The chime tune for each push
button is set with jumpers 7-9.

Single Push Button Kit: If you purchased a kit with a single push button, the chime
tune will be set to Ding Dong from the factory.
Dual Push Button Kit: If you purchased a kit with two push buttons, one push button
will be set to Ding Dong and the other push button will be set to Westminster from the
factory.
The following instructions explain how to change the tune on any wireless push button.

1. Remove the battery from the push button transmitter.

2. Locate the 9 position jumper shown below.

9 position jumper (This pushbutton is set for Ding Dong Chime since 7=off, 8=on, and
9=off.)

3. Select the desired chime sound from the table below.

Chime Sound Table
Position 7 8 9

Westminster ON OFF OFF
Ding Dong OFF ON OFF
Knock OFF OFF ON
Bronze Chime ON ON OFF
Cuckoo Clock ON OFF ON
Foghorn OFF ON ON
Gong ON ON ON

ON: Add a jumper to a location
OFF: Remove jumper from a location.

4. Remove or add the jumpers to match the table.

5. Store unused jumpers as shown.

Parking the jumper on an open set of pins. The two jumpers on the left are in the parked
position.

Setting The House Security Code

Each chime component has jumpers for setting the house security code.
In most cases you will not need to change the factory settings for the
security code. If your chime activates intermittently or does not work at all,
you may be able to solve the problem by changing your security code.

Adding Additional Buttons

When adding a pushbutton to an existing system, you need to check the security code
on the existing chime and match the new pushbutton to that code.

The chime and pushbutton must be set to the same house security code for the
combination to operate together.

Note

that will play. The chime tune jumpers do not affect the house security code.

: The push button has 3 additional jumpers that are used to set the chime tune