GE 19208 User Manual

GE Model 19208

www.jascoproducts.com

Wireless Door Chime Kit

Installation Instructions for Battery Operated
Wireless Door Chime Kit

Prior to Installation the Try-Me feature must be removed.

1. Remove the battery cover on the chime.

2. Remove the white Styrofoam block

3. Unplug the red and black wires inside the battery compartment.

4. Remove the battery pack and discard appropriately.

House Code
Door

Styrofoam
Block

Try-Me Wires

Chime components

Required Tools: Small flat blade screwdriver, drill, 1/16” and 5/32” drill bits,
and phillips screwdriver.

Included Hardware:

(2) Plastic screw anchors
(2) 4x20mm screws
(2) 3x20mm screws
(2) Double sided adhesive pads

The wireless door chime Kit has two components:

Chime (receiver) Push-Button (Transmitter).

Chime Tune Setting

All wireless chimes may have more than one push button. The chime tune for
each push button is set with dip switches 1-3.

Single Push Button Kit: If you purchased a kit with a single push button, the
chime tune will be set to Ding Dong from the factory.
Dual Push Button Kit: If you purchased a kit with two push buttons, one push
button will be set to Ding Dong and the other push button will be set to
Westminster from the factory.

The following instructions explain how to change the tune on any wireless push
button.

1. Remove the battery from the push button transmitter.

2. Locate the 3 dip switches shown below.

3. Select the desired chime sound from the table below.

Chime Sound Table
Position 1 2 3

Westminster ON OFF OFF
Ding Dong OFF ON OFF
Knock OFF OFF ON
Bronze Chime ON ON OFF
Cuckoo Clock ON OFF ON
Foghorn OFF ON ON
Gong ON ON ON

ON: Switch On
OFF: Switch Off

House Code Jumpers

Pushbutton Dip Switches and Jumpers

Chime Dip Switches
(Ding Dong Shown)

Setting The House Security Code

Each chime component has 4 jumpers for setting the house security code.
In most cases you will not need to change the factory settings for the house
security code. If your chime activates intermittently or does not work at all,
you may be able to solve the problem by changing your security code.

1. Remove power or batteries from the chime.

2. To remove the batteries from the pushbutton, open the pushbutton case
as shown below.