GE 165D4051G009 User Manual
Appliances
Installation Instructions
165D4051G009 Dishwasher Door Spring Kit
For installation of a custom dishwasher door panel weighing 3.5 pounds or more
TOOLS AND MATERIALS REQUIRED:
BEFORE YOU BEGIN
Read these instructions completely and
carefully.
• 1/4" socket driver
• Phillips screwdriver
• Gloves to protect agoinst sharp edges
IHPORTANT - Save these instructions for local
inspector's use.
IMPORTANT - observe oil governing codes and
ordinances.
Note to Installer - Be sure to leave these instructions with
the Consumer.
Note to Consumer - Keep these instructions with your
Owner's Manual for future reference.
A
To prevent electric shock, disconnect electrical power
supply to dishwasher before changing springs. Do not
operate dishwasher while changing springs or when
toekick assembly is removed.
WARNING:
KIT INCLUDES:
• 1 set of springs
• 2 plastic links
imagination at work
step l“Turn off power and water Step 6-Check door balance
•Turn off power supply.
•Turn off water supply.
• Lotch dishwasher door.
Step 2”Move dishwasher
• Remove the two screws securing the dishwasher to the
countertop or side.
• Pull the unit out from the cabinets approximately 10", until
the door springs are exposed.
A
■ All dishwashers can tip when removed from enclosure.
> Injury to persons could result.
> Use caution when opening door.
• Check the door balance by opening and closing the door
« If door drops open when released, increase spring tension.
If door closes when released, decrease tension.
WARNING:
Step 3”
Remove
toekick
' Remove the screws on
each side of the toekick
face.
• Retain screws.
• Remove the toekick from
the dishwasher and set
aside.
Step 4”Remove old springs
• Grasp the upper end of the spring attached to the dishwasher
frame and release the hook.
• Release opposite end of the spring from the tension cable
and remove the spring.
Step 5“lnstall
new springs
• Place the short end of
the spring hook into the
eyelet of the tension
cable.
• Stretch the long end of
spring and hook into the
lowest notch of the frame
bracket.
• Repeat the same
procedure for the
opposite side.
Insert \
Hook \
Over i
Bracket /
Correct
Incorrect
Note: Increase or decrease tension as shown. Adjust both springs to
the same tension setting to correct balance.
Tip: If door does
not open easily or
falls too quickly,
check spring coble
routing. The cable
is held in place by
"shoulders" on the
pulley. Check to be
sure cable has not
¡Correct slipped over the
pulley shoulders
and onto the axle.
incorrect
Step 7-Reinstall toekick
• slide dishwasher back into opening. DO NOT PUSH AGAINST
FRONT PANEL WITH KNEES. DAMAGE WILL OCCUR.
• Reinstall the 2 screws securing the dishwasher to the
countertop or sides and ensure door springs do not contoct
water line, fill hose, wiring, etc.
• Turn water on.
• Turn electrical power on.
GE Consumer & Industrial
General Electric Company
Louisville, Kentucky 40225
ge.com
Knee. Damage to The
Door Panel Will Occur.
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE Pub. No. 31W0593
DWG. N0.206C1559P137
05DW297 5/05
Loading...