GE 106585, 71415 User Manual

Household Type
Owner’s Guide Model 106585
Important Safeguards ........ 2
Service Information ............ 3
Assembly .......................... 4-5
Use .................................... 6-7
Thermal Cut Off ........... 3 & 7
Hose Blockage ..................... 9
Brush Roll .......................... 10
For Customer Assistance Please Call: 1-877-556-0973
Part No. 71415 (2/01)
Brush Roll Belt .............. 10-11
Cyclonic Dust Cup........ 11-12
Filters ............................ 12-13
Light Bulb .......................... 14
Problem Solving ............... 15
Warranty ............................ 17
Customer Order Form ...... 19
www.wal-mart.com
Vacuum Cleaner Safety

IMPORTANT SAFEGUARDS

When using an electrical appliance, basic precautions should always be followed, including the following:
READ ALL INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER.
WARNING
To reduce the risk of fire, electric shock, or injury:
Do not use outdoors or on wet surfaces.
• Do not leave vacuum cleaner when plugged in. Turn
off the switch and unplug the electrical cord when not in use and before servicing.
Do not allow to be used as a toy. Close attention is necessary when used by or near children.
Use only as described in this manual. Use only manufacturer’s recommended attachments.
Do not use with damaged cord or plug. If vacuum cleaner is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, have unit serviced before using.
Do not pull or carry by cord, use cord as a handle, close a door on cord, or pull cord around sharp edges or corners. Do not run vacuum cleaner over cord. Keep cord away from heated surfaces.
Do not use extension cords or outlets with inadequate current carrying capacity.
Turn off all controls before unplugging.
Do not unplug by pulling on cord. To unplug, grasp
the plug, not the cord.
Do not handle plug or vacuum cleaner with wet hands.
Do not put any object into openings. Do not use with any opening blocked; keep free of dust, lint, hair, and anything that may reduce airflow.
This vacuum cleaner creates suction and contains a revolving brush roll. Keep hair, loose clothing, fingers, and all parts of body away from openings and moving parts.
Do not place cleaner on furniture or stairs as the brush roll may cause damage. Place cleaner on floor with the handle in storage position while using attachments.
Do not pick up anything that is burning or smoking, such as cigarettes, matches, or hot ashes.
Belt pulleys can become hot during normal use. To prevent burns, avoid touching the belt pulley when servicing the drive belt.
Use extra care when cleaning on stairs.
Do not use to pick up flammable or combustible
liquids such as gasoline, or use in areas where they may be present.
Store your cleaner indoors in a cool, dry area.
Keep your work area well lighted.
Unplug electrical appliances before vacuuming
them.
SAVE THESE INSTRUCTIONS
2
To reduce the risk of electric shock, this appliance has a polarized plug (one blade wider than the other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet. Do not change the plug in any way.
Afin de réduire le risque de choc électrique, cet appareil est muni d’une fiche polarisée (une des lames est plus large). Cette fiche ne peut être insérée dans une prise polarisée que d’une seule façon. Si la fiche ne peut être insérée dans la prise, retourner la fiche. Si la fiche ne peut toujours pas être insérée dans la prise, faire installer une prise adéquate par un électricien qualifié. Ne pas modifier la fiche.
General Information
The cleaner is designed to pick up dirt and dust particles. Avoid picking up hard or sharp objects with the cleaner to prevent hose clogs.
DO NOT OIL the motor or the brush roll at any time. The bearings are permanently lubricated and sealed.
Customer Assistance
The instructions in this booklet serve as a guide to routine maintenance. For additional service information please call, 1-877-556-0973. You should know the model, type and serial numbers when you call.
Rating Plate
The model, type, and serial numbers are indicated on the rating plate located on the underneath side of the cleaner. For prompt and complete service information, always refer to these numbers when inquiring about service.
Model & Type__________________________
Serial No. _____________________________

Thermal Cut Off

This vacuum cleaner has a special thermostat that protects the cleaner in case of motor overheating. If the cleaner suddenly shuts off, turn the switch off and unplug the cleaner. Check the cleaner for a possible source of overheating such as a blocked hose or clogged filters. If these conditions are found, fix them and wait at least 30 minutes before attempting to use the cleaner. After the 30 minute period, plug the cleaner back in and turn on the switch. If the cleaner still does not run, then call 1-877-556-0973 for customer assistance.
3
How To Assemble
CAUTION: Assemble the cleaner completely before plugging into an electrical outlet. CAUTION: Moving parts, stay clear of brush roll when plugging in.
NOTE: Features may vary by model yet all parts assemble the same.
Step A Remove Dust Cup
Dust Cup Latch
Dust Cup
Handle
Two Screw Locations
##
#
##
Step B Attach Handle
Handle
Tabs
Slots
Dust Cup
1. Remove dust cup from unit to expose the two screw installation locations. Release the dust cup by rotating the dust cup latch to the left. Pull out and up on the dust cup handle to remove from unit.
Screw
2. Position handle as above. Slide the handle down over the top of the unit, inserting handle tabs into slots on unit.
3. Find the two screws in the accessory bag included in the carton. To secure the handle on the unit, install the two screws.
Screw
4
Step C Replace Dust Cup
Dust Cup
Latch
##
#
##
Step D Store Accessories
Dusting/
Upholstery
Brush
Crevice
Tool
Nesting
Extension
Wands
(shipped
stored on
cleaner)
Groove
4. Replace dust cup by aligning front of the bottom of dust cup into groove on cleaner. Pivot dust cup up against cleaner and rotate the dust cup latch to the right to secure.
Step E Store Electrical Cord
5
Cord
Retainer
6
Cord Hook
5. You will find your cord retainer on the handle above the upper cord hook. Firmly push the electrical cord down into the cord retainer. This will place the cord out of the way the next time you vacuum.
6. Next wind the cord around the two cord hooks on the back of the cleaner.
6
Cord Hook
7. Secure the plug to the cord to prevent unwinding.
5

How To Use

1. Cord Retainer. To use, push electrical cord down into cord
retainer.
CAUTION: Do not plug in cleaner until you
understand all controls and features.
1
2
3
2. ON/OFF Switch. International symbol I means On,
International symbol O means Off.
3. Dust Cup Latch. When dust cup latch is pointing to the left,
the dust cup compartment is unlocked. When dust cup latch is pointing to the right the dust cup is locked in place. See the locked/unlocked symbols on the unit.
4. HEPA Filter Compartment. To open, slide HEPA filter door
up and pull away from unit. To close, place HEPA filter door at top of opening pressing against unit, slide down into place.
5. Dust Cup Handle. Use the handle to remove and replace
the dust cup in the dust cup compartment.
6. Dust Cup Compartment. To open, turn dust cup latch (3)
to the left pointing to unlock symbol, then grasp dust cup handle (5) and pull dust cup out and away from unit. To close, place the front of the bottom of the dust cup in groove at the bottom of dust cup compartment, rotating dust cup up and against unit. Then turn dust cup latch to the right pointing to the lock symbol.
7. Stair Handle. To use when cleaning stairs.
8. Handle Release. Step on handle release. Pull handle back to
a comfortable position. Press release again to lower handle further to clean under furniture.
9. Light Bulb Compartment. To gain access to light bulb
compartment remove the two screws in the lens.
13
11
12
10. Brush Roll Belt Window. To check condition of belt watch
4
5
6
7 8
9
10
11
to see if white dots on belt are moving through the window. This indicates the brush roll is turning.
11. Screws to Release Hood. Remove these screws to release
hood and give access to brush roll belt area.
12. Cleaner Height Setting. The front of the cleaner has an
adjustment that raises or lowers the cleaner base to match the type of floor surface. With the cleaner cord unplugged, set the adjustment to lowest setting for maximum carpet cleaning. If the cleaner is difficult to push, move adjustment to next highest setting until cleaner is comfortable to push. The brush roll must reach the carpet for effective cleaning. For ease in moving the adjustment knob, place handle in operating position and tilt cleaner back to remove weight from front wheels.
WARNING: Avoid injury. Keep loose clothing, hair, fingers,
and all other parts of body away from any moving part (such as the revolving brush). Turn off the switch and unplug the cleaner before changing the cleaner height setting.
13. Extension Wands. Use these wands on the end of the hose
for added cleaning reach.
6
Loading...
+ 13 hidden pages