GBC RDX1619, RSX128, GDM10, RDX1413, RDS1819 User Manual

...

RSX128

RDS1713 RDX1413 GDM10 GDHS7 RDS1819 RDX1619

Instruction Manual Manual de instrucciones Manuel d’utilisation

To register this product go to www.gbc.com. Pour enregistrer ce roduct allez sur www.gbc.com. Para registrar este producto vais en www.gbc.com

Speciﬁcations

Models

Sheet Capacity -

Duty Cycle -

Volts / Hz -

Amperage

RSX128

12 sheets

4 min on / 30 min off

2 min on / 10 min off

2 min on / 20 min off

120V AC / 60Hz

5.0A

RDS1713

17 sheets

10 min on / 20 min off

3 min on / 20 min off

120V AC / 60Hz

8.0A

RDX1413

14 sheets

10 min on / 20 min off

3 min on / 20 min off

120V AC / 60Hz

8.0A

Models

Sheet Capacity -

Duty Cycle -

Volts / Hz - 120V AC/60Hz

Amperage

IMPORTANT: ONLY INSERT ONE CD OR ONE CREDIT CARD AT A TIME. Models GDM10 and GDHS7 can not shred CDs, Credit Cards, paper clips or staples

GDM10

10 sheets

10 min on / 20 off

N/A

120V AC / 60Hz

9.0A

GDHS7

7 sheets

10 min on / 20 off

N/A

120V AC / 60Hz

9.0A

English 4 Français 8 Español 12

RDS1819

18 sheets

5 min on / 20 min off

3 min on / 20 min off

120V AC / 60Hz

9.0A

RDX1619

16 sheets

10 min on / 20 min off

3 min on / 20 min off

120V AC / 60Hz

9.0A

Models: RSX128 Models: RDS1713, RDX1413, GDM10, GDHS7,

RDS1819, RDX1619

Illuminated Panel

1 2 3 4 5 6 7

Lights and Icons Explained

1 2 3 4 5 6 7

Illumination Power Happy Sad Anti- Door Cool Bin on face face jam open down full

Color Green Red Amber Green Red Red Red Amber Red

Power on button pushed / no fault light Door open light light ﬂash Bin full light light ﬂash Motor overheat light light ﬂash Auto button pushed / shredding light light light Anti-jam at Measure mode light light light ﬂash Anti-jam at Running mode light light light ﬂash Forward jammed light light light Reverse jammed light light light Reverse button pushed light light Auto mode light light light

Introduction

Thank you for choosing this shredder from Rexel. We are sure it will serve you well, but please take a little time to study these instructions to ensure you get the best out of your machine.

a Indicator Panel b RSX128: Pull Out Drawer

RDS1713, RDX1413, GDM10, GDHS7,

RDS1819, RDX1619: Door for Bin

c Wheels d Power On Button e Auto Feed Button f Reverse Button g CD Guide (not ﬁtted on GDM10 and GDHS7)

1 Power On (Amber Light) 2 Shredder OK (Green Light) 3 Shredder not OK (Red Light) 4 Anti Jam. Too many sheets (Red Light) 5 Door Open (Red Light) 6 Cool Down (Amber Light) 7 Bin Full (Red Light)

g CD Guide (not ﬁtted on GDM10 and GDHS7)

Safety First

Shredders are safe to use as long as you take a few safety precautions.

• Ensure the machine is plugged into an easily accessible

power outlet, and ensure the cable is not likely to trip up a passer by.

• Any attempt to repair this unit by unqualied personnel will

invalidate the warranty. Please return to supplier.

• Unplug your shredder before moving it or when it is not in

use for an extended period of time.

• Do not operate with a damaged power supply cord or plug,

after it malfunctions, or after it has been damaged in any manner.

• Do not overload electrical outlets beyond capacity as this can

result in ﬁre or electrical shock.

• The socket-outlet should be installed near the equipment and

shall be easily accessible.

• Do not alter the attachment plug. The plug is congured for

the appropriate electrical supply.

• Do not use near water.

• Do not use aerosol dusters or cleaners.

• Do NOT Spray anything into the shredder.

Although this shredder has been designed to be child safe, it is not advised to operate the machine near children.

Shredder Control Panel

ReverseForwardOn/Off

Safety First

This means you should be careful because long hair can become entangled in the cutting head. This could hurt you.

This means don’t reach into the feed opening of the cutting head. This could hurt you.

This means be careful of ties and other loose clothing which could become entangled in the cutting head. This could hurt you.

This means keep children away from shredder.

This means do not use aerosol sprays anywhere near the unit.

This means be careful of loose jewelry which could become entangeld in the cutting head.

Door Open Safety Function

If the door is opened during shredding as a safety precaution the shredder will instantly stop, and the door open symbol on the indicator panel will ﬂash red. The green will go off and the red will illuminate. To resume shredding, shut the door and press the auto button.

Jam Free™ Technology

Jam Free Shredders will only shred stacks of paper that are within the shredders sheet capacity.

Sensors in the paper feed area measure the thickness of paper about to be shredded. The ability to shred or not is communicated through red and green lighting. Green means that the stack of paper is within the shredders sheet capacity and OK to shred. Red means that you have too much paper, remove some sheets in order to shred.

Given that you are unable to shred more sheets of paper than the shredder is capable of shredding, paper jams are prevented.

This prevents time wasted through reversing paper and unblocking jams not to mention the mess it can create.

RDM1050 and RDSM750 only.

This means do not shred CD’s.

This means do not shred credit cards.

This means do not shred paper clips.

This means do not shred staples.

Rare Occasions of Jamming

In the unlikely event of the shredder jamming, use the reverse function to unblock the shredder. (see Reverse function section)

Alternating between the reverse function and the forward run (Hold Auto start for 2 seconds) will help unblock the feed area.

Once the jam is clear, press the right hand auto button once to revert back to auto mode. You can now resume shredding as normal.

Over Heating

If the shredder is used continuously for long periods of time the shredder may overheat. If this occurs the thermometer symbol on the indicator panel will ﬂash amber, the green will go off and you will see the red .

When the shredder is ready to be used again the thermometer symbol will stop ﬂashing and the green again. To resume shredding press the auto button.

will show once

Operation

1 After unpacking the product, pull out the shredder bin and

remove the CD shard tray,which sits on top of the bin. Store this tray somewhere safe and use when you shred CD’s or credit cards to separate waste for recycling. (not applicable for GDM10 and GDHS7 models)

2 Connect shredder to mains supply. 3 Press the central power on button (d). This will switch the

power on and all the LED warning symbols on the indicator panel (a) will ash in sequence. The shredder will now be in standby mode and the “Power-on” symbol on the indicator

panel will be illuminated amber.

4 To start shredding, press the right hand auto feed button (e)

this will illuminate the feed area green and illuminate the symbol green.

This sets the shredder into auto mode and initiates the Jam

Free mechanism. You are now able to shred.

5 Insert paper to be shredded into the feed area. The Jam

Free mechanism will sense the thickness of the paper being shredded.

If the paper thickness is within the shredder’s capacity,

the motor will start and your documents will be shredded. Cutters will stop once the shredding process is complete.

If the paper thickness is greater than the shredders sheet

capacity the area around the feed slot will turn from green to red and the motor will not run. In this situation the Jam Free Icon on the indicator panel will ﬂash red, the green will go off, instead the will be illuminated red.

6 If this happens, remove some of the sheets from the paper

stack and re-try until the feed area reverts back to green,

the shredder will then automatically start and allow the paper to be shredded.

If the shredder is left in auto mode for more than 10

minutes without being used, the shredder will automatically turn back to standby mode in order to save power.

Reverse Function

1 Should you wish to reverse the shredding direction while

shredding a document, a reverse button (f) has been ﬁtted for your convenience.

2 By pressing the reverse button the shredding cutters will

change direction allowing the retrieval of the document being shredded. The feed area will turn to red.

3 The reverse function will only run while the button is being

pressed. When the reverse button has been released the shredder will revert to stand by mode.

4 To turn back to auto mode simply press the right hand auto

feed button again (e).

CD and Credit Card Shredding

Models GDM10 and GDHS7 can not shred CD’s or credit cards therefore this section is not applicable to these two models. All other Jam Free models can shred CD’s and credit cards as follows:

1 A separate CD tray is provided to collect the shredded

CD shards. Ensure that this is correctly mounted onto the

standard shredder bin before shredding CD’s or credit cards. CD and credit card shards should be disposed of separately to paper.

2 Pull up the orange CD guide (g) located in the center of the

feed area and ﬂip it into position over the shredder mouth.

3 For credit card shredding, switch the shredder to auto mode

and insert the card into the center slot. Only shred 1 credit card at a time.

4 For CD shredding, extend the sides of the orange CD guide,

switch the shredder to auto mode and place the CD into the center of the CD slot. Only shred 1 CD at a time.

5 Empty the CD tray after 8 credit cards or CD’s to avoid

waste spilling over into the paper waste bin. Remove the CD tray before recommencing to shred paper.

+ 12 hidden pages