Gatco 1563 User Manual
GENERAL INSTALLATION INSTRUCTION
BLEU DECORATOR MIRROR
PREPARATION
Tools Required for Assembly: (not included)
• Pencil
• Electrical drill with 5/16 in. drill bit
Caution: Molly bolts are for dry walls only. Use tile anchors for tile surfaces. (not included)
Caution: Two people are required to safely install this oval mirror. The mirror will break if dropped. Take extra precautionary
measures to ensure a secure grip on the parts.
INSTALLATION INSTRUCTION
• Philips head screwdriver
• Tape measure
• Level
• Safety glasses
• Hammer
1. Once the location of the
mirror has been determined,
mark the positioning of the
four mounting brackets (A)
and their screw holes with a
pencil. Use a measuring tape
and a level for accuracy.
(Fig. 1)
2. Drill 5/16 in. pilot holes
into the wall where the Molly
bolts will be inserted using an
A
electrical drill.
Fig. 1
Front View
3. Tap Molly bolts (B) into the pilot holes using a hammer.
4. Use an electrical
screwdriver to tighten the
screws. This will collapse the
Molly bolts (B) tightly to the
B
wall. (Fig. 2)
Side View
B
5. Unscrew the screws (b)
from the Molly bolts (B).
Molly bolts will remain in the
Fig. 2
f
b
wall. (Fig. 3)
Fig. 3
Side View
6. Place the mounting bracket (A) over the Molly bolts (B). Insert
the screws (b) back through the bracket and the Molly bolts, and
then tighten firmly with Philips head screwdriver.
8. Tighten their set screw (D)
with Allen wrench (E). Make
sure that the opening of the
groove is facing up. (Fig. 5)
9. Rest the mirror (F) on the
lower mirror brackets (C), and
place the two upper brackets
on the top edge of the mirror.
(Fig. 6 and 7)
10. Align the two upper mirror
brackets (C) with their
respective mounting brackets
(A). Carefully push them over
the pins. (Fig. 7)
11. Tighten their set screw (D)
with Allen wrench (F). Make
sure the opening of the groove is
facing down (C). (Fig. 8)
Fig. 5
F
Fig. 6
Fig. 7
Side View
Fig. 8
D
C
C
F
D
C
E
A
Side View
G
Fig. 9
7. Secure the two lower mirror
brackets (C) to the wall by
placing them over the
mounting brackets. (Fig. 4)
Fig. 4
A
12. Tighten the set screws (G)
in each of the four mirror
brackets with Philips head
C
screwdriver. Tighten until just
snug – do not over tighten.
(Fig. 9)
CARE AND MAINTENANCE
To maintain the beautiful luster finish, please use soft damp cloths when cleaning and never use any cleaning solvents.
Loading...