Gatco 1423 User Manual

GENERAL INSTALLATION INSTRUCTIONS

PREPARATION

Tools Required for Assembly: (Not included)

• Electrical drill with 5/16 in. drill bit

• Mallet hammer

CAUTION: Drywall anchors are for drywalls only. Use tile anchors for tile surfaces. (included)

INSTALLATION INSTRUCTIONS

1.

Hold the swing mirror (A) up against desired position on wall, and

mark the position of screw holes. (B) Remove the item. (Fig. 1)

• Phillips head screwdriver

• Safety glasses

Swing Mirror (Drywall installation)

B

A

2. Drill 5/16 in. pilot holes into the wall where the drywall anchors (C)
will be inserted.

4. Pinch drywall anchors (C) two wings together (Fig. 2), and insert it into the

hole horizontally. Tap flush with the wall using a mallet hammer.

5. Insert the red push pin (D) into the drywall anchors (C)

until the wings pop open. (Fig. 3) Then remove the pin.
Do not tap the red push pin with a hammer.

6. Place the swing mirror (A) over the drywall anchors (D).

Insert mounting screws (E) through the bracket and anchors,
and then tighten firmly with Phillips head screwdriver. (Fig. 4)

Fig. 1

C

Fig. 2

Push

Fig. 3

Side View

Fig. 4

a. b. c.

a. b.

C

D

Top View

E

D

CARE AND MAINTENANCE

To maintain the beautiful luster finish, please use soft damp cloths when
cleaning and never use any cleaning solvents.