Gasmate EH600 User Manual

OPTIMUM RADIANT HEATER

EH600 SERIES

Metal radiant heater with non glowing element

Adjustable wall and ceiling bracket

Black anodised aluminium

1.5m long power cord

Designed for indoor and outdoor use

Ideal for use in alfresco areas, verandahs and garages

EH633 & EH633R requires 15A power point to be

installed by qualiﬁed electrician

03455 05/16

Gasmate® is a registered trademark of

Sitro Group Australia Pty Ltd www.gasmate.com.au

Aber Living www.gasmate.co.nz

Important: Retain these instructions for future use

03841 11/18

INSTALLATION, OPERATION & MAINTENANCE INSTRUCTIONS

Safety

Before attempting to operate this heater, the following basic safety precautions should be taken to reduce

the risk of re, electric shock and personal injury. It

is important to read the instruction manual and to

understand its’ applications, limitations and potential

hazards associated with this heater. This heater is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety. This heater is not designed for use within 1m or above

a water source. It is important that you read, understand

and follow these instructions very carefully. They are designed for the safety of yourself and others ensuring a long and trouble free service life from your heater. This

electric heater complies with Australian and International

standards and safety requirements. Repairs should only

be carried out by qualied persons using original spare

parts. Failure to do so may result in considerable danger to the operator.

FOR YOUR SAFETY

WARNING: Fire risk exists if this heater is covered by

or positioned close to curtains or other combustible materials.

NOTE: If using this heater outside ensure that it is

connected directly to an outdoor power point.

The electrical system of this heater must be connected with an automatic 30mA circuit breaker

and/or residual current device (RCD). If uncertain have a qualied electrician check your electrical

system before installation and/or use.

All electrical connections are made in a dry area.

Outdoor power points must be weatherproof and

installed by a qualied electrician.

Sitro Group Australia Pty Ltd is not responsible for

incorrectly chosen xing accessories or any damage which may be caused by an incorrectly tted wall

heater.

If required 15AMP power points must be installed by a qualied electrician.

SAFE OPERATION

Beware of Children and Pets

Children should not be allowed to touch or operate heaters or touch extension cords, if used. All heaters should be kept out of reach of children, preferably stored or locked in a secure cabinet or room when not in use.

Do Not Abuse the Power Cord

Never yank or pull on the power cord to disconnect it from

the mains supply socket. Never carry your heater by its’

power cord. Keep the power cord away from heat, oil, solvents and sharp edges. Check the power cord regularly for any damage and if the power cord becomes damaged have it replaced by an authorised service facility.

Extension Cords and Reels

This heater is NOT designed to run off an extension cord.

If you require an additional power point please have one installed by a qualied electrician.

The use of extension cords may cause power voltage loss which will result in damage to the appliance this will NOT be covered under warranty.

Installation

Always ensure you select the correct xing accessories

which suit the particular wall/ceiling material you are attaching to, if in doubt please discuss with your local retailer or local hardware store. This heater is not designed for use within 1m or above a water source. All installations must meet the requirements of Australia Standard AS/NZS 3000:2007.

Ensure that the heater is not positioned directly above, below or in front of a power point or switch.

This heater is not designed to be used with 3rd party timer or programmable system.

For any queries or assistance call

Customer Service

Australia Only

1300 174 876

Hours of operation:

Monday to Friday 8am - 5pm AEST

Do not return to place of purchase.

Keep your purchase receipt, this will be required to

make any claims under the 12 month warranty.

SPECIFIC SAFETY INSTRUCTIONS

WARNINGS

Do not use the heater in areas where there is a risk of explosion or ﬁre from ﬂammable gases. Ensure that the heating area is kept clear of combustible materials. Do not use the heater in damp areas, without suitable ventilation. This heater is not designed for use within 1m or above a water source. Do not place within one metre (1m) of any water source. Do not place directly in front of, below or above any power points or switches.

Fire risk exists if this heater is covered by or positioned close to curtains or other combustible materials.

• This heater is intended for domestic/household use only.

• Always ensure that this heater is installed as per the requirements noted in Australian Standard AS/NZS 3000:2007.

• Always keep heater at least one metre (1m) from combustible materials.

• DO NOT locate this heater directly below, above or in front of the power supply socket or switch.

• DO NOT use this heater within 1 metre or above any water source.

• DO NOT use this heater in either the bathroom or ensuite without suitable ventilation.

• DO NOT use a 3rd party timer, or programmable system with this heater.

• DO NOT clean the heater while the heater is on or plugged into the mains power supply.

• DO NOT touch any part of the heater while on, hot surfaces may burn.

• DO NOT use the wall heater as a dryer.

• DO NOT attempt to modify the heater, power cord, power plug or the supplied accessories in any way.

• DO NOT expose the heater to rain, water, or use in damp wet conditions.

• NEVER cover this heater.

• NEVER carry the heater by its power supply cord.

• NEVER use with the power cord coiled, bundled up or tied up. Always extend fully before use.

• NEVER use the heater if any part of it is damaged.

• Ensure that the heater is disconnected from the mains supply when installing, cleaning or removing/ installing.

• Ensure this heater is not left on when unattended.

• Ensure the heater is not used in areas where ﬂammable gases are present, e.g. paint, petrol etc.

• Always turn the heater OFF at the unit switch and the power point switch when not in use for extended periods of time.

• Always allow the heater to cool, about one (1) hour after the heater has been turned off, before cleaning the heater.

• Always ensure that the power cord is fully extended and NOT in contact with any part of the heater.

• Always ensure that the heater is kept clean and free from dust.

• Only use this heater when securely attached to the wall/ceiling.

+ 5 hidden pages