Gasboy Hard Drive User Manual

INSTALLATION INSTRUCTIONS: HARD DRIVE OPTION KIT C05986

This kit should contain the following:

Item P/N Description

1 C34412 Bracket, HD Support
2 C09162 Hard Disk Drive, SCSI
3 C04035 Screw, #6-32 x 1/4” (Qty 4)
4 068843 Washer, #6 Locking (Qty 4)
5 C01152 Screw, #4-40 x 1/4” (Qty 2)

Item P/N Description

6 C01159 Washer, #4 Locking (Qty 2)
7 C03473 Nut, #4-40 Hex Keps (Qty 2)
8 C05984 Cable Assy., HD Ribbon
9 C05552 Cable Assy., HD Power
10 C34410 Cover Bracket

System Requirements: C05852 CPU PCB containing a Dsite chip (U36) of version 4.0F. The hard drive is not
compatible with the C05328 CPU PCB. If your system does not meet this requirement, consult your sales
representative.

Important: Before you begin, make sure you have copies of your Release and Applications disks and a
backup of your site data. Change your command search path in SYS_PAR, page 9 to default (spacebar)
and save this change.

1. Turn off power to the unit and remove the cover.

2. Remove spot-welded cover plate, if present, from Drive B position on base.

3. Remove the original disk drive support bracket from the cover.

4. If the disk drive support mounting bracket already has
mounting holes for a hard drive, skip to the next step. If
not, relocate the original 3-1/2” drive to the new support
bracket (item 1).

5. Verify that the drive is jumpered as shown below:

Fujitsu:

6. Mount the new hard drive to the drive support brack et us ing
four screws and washers (items 3 & 4). Mount cover
bracket (item 10) to drive s upport br ac k et us ing two s c rews,
washers, and nuts (items 5, 6 and 7).

7. Mount the drive support bracket onto the cover.

8. Adjust the position of the drive and dr ive s upport br ack et s o
the cover slides easily onto the base.

9. Plug the 68-pin to 50-pin adapter into the hard drive. T hen
plug the 50-position ribbon cable (item 8) into P14 of the
CPU PCB and plug the opposite end into the adapter.

10. Plug the power cable into the power supply, and then into
the hard drive.

11. On the CPU Board, close DIP switch 1, position 2 to enable
the hard drive.

12. Reinstall the cover, without mounting screws, and turn on the power. You should hear the hard drive begin to
spin.

13. Reinstall the cover mounting screws.

C35348 Rev. 07/02/03 Page 1

Installing Your SC II Software on Your New Hard Drive

1. Insert the Applications disk into drive A. Type A:BIN/RCP A: C:. This will copy the Applications disk to the
hard drive.

2. Remove Applications disk from drive A and insert the Release disk. Type RCP A: C:. This will copy the
Release disk to the hard drive.

3. Remove the Release disk from drive A. If you have other disk s containing files you want on the hard drive,
insert the disk into the A drive and type RCP A: C:

Page 2 C35348 Rev 07/02/03