Gasboy Fuel Point-Special Hose User Manual

ASSEMBLY INSTRUCTIONS FUEL POINT SPECIAL HOSE ACCESSORIES

General

Standard dispenser modification kits ar e designed for hoses that do not ex ceed 15 feet in length.
When extra long hoses are required with Fuel Point, the following special accessories may be
required and must be ordered separately.

36 Foot Wire Assembly, C06799

This wire assem bly is designed to use "as is" for external hose wire applications exc eeding the
standard 24-foot kit wires supplied. Also see C09496 extra-long 24-foot hose sleeve when
required.

When fabric ating the extra long hoses configured for internal wire, add the brass fittings and O­ring furnished in the standard kits to this wire assembly.

Starting at the connector end, measure 6" and c ut the wire. Carefully feed the wire thr ough the
large female thread exiting through the 5/16 threaded hole. Slide the O-ring and sm all fitting on
the wire and strip the outer jacket to about 1", conductors to 1/4", and crimp using two butt
connectors supplied. Apply heat to shrink the crimp connection.

CAUTION: Assembling the brass fittings by splicing and using butt connectors eliminates

sliding the brass fittings and O-ring the entire length of the hos e wire. Sliding the
fittings can damage the outer wire jacket within the hose and caus e fuel leaks at
the environmental connectors.

20" Flex Tubing Kit, C07031

Special applications may require protecting exposed N-ring wire when fitting covers cannot be
located directly at the dispenser. Typically, this occurs when external fuel filters or breakaway
fittings are attached at the dispenser.

The tubing kit starts under the hos e cover nearest
the dispenser and runs into the dispenser. To
protect the wire, two (2) nylon bushings are
supplied and are held in place with tiewraps as
shown in the diagrams at right.

Be sure to slide the bushings so that the flex
tubing is compressed before installing tiewraps.

C35843 Rev. 6256