Garland GF24-BRL, GF30-BRL, GF36-BRL General Manual
GF Sentry Flame Failure Series
Range Match Broiler
Models:
GF18-BRL GF24-BRL GF30-BRL GF36-BRL
Item: ______________________________
Quantity: __________________________
Project: ____________________________
Approval: __________________________
Date: ______________________________
GF Sentry Flame Failure Series Range Match Broiler
Model GF24-BRL
Standard Features:
• Stainless steel front, sides,
front rail, hopper & side
splash guards.
• Stainless steel low profile
back-guard
• Counter mount or range
matched to Garland GF series
ranges (when combined with
optional stand or cabinet base)
• Exclusive lift off hopper top
• Removable broiling grates
23" (584mm) deep in 6"
(152mm) wide sections.
• Dual-sided cast iron broiler
racks, 1/2" (13mm) rounded
bar (broad) or diamond patterns (fine) on opposite sides
in 6" (152mm) wide sections.
• Heavy duty ceramic briquettes
• 4" (102mm) sanitary legs for
counter mount installations
• Flame failure protection
Hi-Lo valves • Piezo Spark
Pilot Ignition
• 3/4" N.P.T. rear gas connection
• Gas pressure regulator supplied with North American
units.
• 15,000 BTU cast iron burners for every 6" (152mm) of
broiler space.
Optional Features:
Diamond branding rack in
lieu of standard rack
Stainless steel splatter
guard 18" (457mm) to 48"
(1219mm), specif y width
Nickel plated wire type hold-
ing shelves which attach to
spatterguards, available in
18” (457mm), 24” (610 mm) &
36” (914mm)
Note: Stands and floor bases
available see form BRL-STD
Specifications:
Range match Broilers available in four widths: 18" (457mm), 24"
(610mm), 30" (762mm), and 36" (914mm). Designed to match GF
sentry series ranges. Standard finish stainless steel front, sides, and
backguard. Exclusive lift off stainless steel grease hopper. Dual
sided cast iron broiler racks, 1/2" (13mm) rounded bar (broad) or
diamond patterns (fine) on opposite sides in 6" (152mm) wide sec-
tions. In lieu of standard broiler racks dual diamond pattern racks
are available. Simple set Hi-Lo valves are located away from heat
and protected. 15,000 BTU cast iron burners for every 6"(152mm)
of broiling width, natural or propane gas. Flame protection sys-
tem with Piezo ignition. Optional cabinet BRL-CAB or open frame
stand BRL-STD, see specification form BRL-STD.
Garland Commercial Ranges Ltd
1177 Kamato Road,
Mississauga, Ontario
L4W 1X4 CANADA
Phone: 905-624-0260
Fax: 905-624-5669
TM
A*
25-1/8"
[638mm]
3/16"
[5mm] MIN
1/2"
[13mm] MAX
22-3/8"
[568mm]
7/8" [21mm]
5-5/8"
[143mm]
2"
[53mm]
15-7/8"
[404mm]
3"
[77mm]
22-1/8"
[562mm]
31-1/8"
[91mm]
14-3/4"
[375mm]
3-5/8"
[94mm]
REAR GAS
CONNECTION
GF Sentry Flame Failure Series Range Match Broiler
Model
Height w/O Legs Width Depth Cu Ft lbs/Kg BTU kW
GF18-BRL 25-1/8" (638mm) 18" (457mm) 34-1/2" (876mm) 21 190/86 45,000 13.2
GF24-BRL 25-1/8" (638mm) 24" (610mm) 34-1/2" (876mm) 21 240/109 60,000 17.6
GF30-BRL 25-1/8" (638mm) 30" (762mm) 34-1/2" (876mm) 29.5 290/131 75,000 22
GF36-BRL 25-1/8" (638mm) 36" (914mm) 34-1/2" (876mm) 29.5 340/154 90,000 26.4
Gas Inlet
3/4" NPT
Sides 6"(152mm) Back 6"(152mm) 4.5"WC (10mbar) 10"WC (25mbar)
1-3/8"
[45mm]
Exterior Dimensions Shipping
Installation Clearances
Non-Combustible Surfaces Only
Sides Rear Natural Propane
Manifold Operating Pressure
REAR GAS
CONNECTION
Total Input Rating
(Natural Gas)
Gas input ratings shown here are for installations up to 2,000 ft. (610m) above seal level.
Specify altitudes over 2,000 ft.
Garland/U.S. Range products are not approved
or authorized for home or residential use, but
34-1/2"
[876mm]
24-1/4"
[617mm]
are intended for commercial applications only.
Garland / U.S. Range will not provide service,
warranty, maintenance or support of any kind
other than in commercial applications
25-1/8"
[638mm]
3/16"
[568mm]
[5mm] MIN
1/2"
[13mm] MAX
Garland Commercial Ranges Ltd
1177 Kamato Road,
Mississauga, Ontario
L4W 1X4 CANADA
Phone: 905-624-0260
Fax: 905-624-5669
5-7/8"
[149mm
WIDTH
22-3/8"
7/8" [21mm]
[127mm]
5-5/8"
[143mm]
5"
Please specify gas type when ordering.
15-7/8"
[404mm]
3"
[77mm]
22-1/8"
[562mm]
31-1/8"
[91mm]
2"
[53mm]
Form# GF-BRL (08/05/10)
14-3/4"
[375mm]
3-5/8"
[94mm]
REAR GAS
CONNECTION
Loading...