Garland EFW400 Installation Manual

INSTALLATION AND

OPERATION MANUAL

GARLAND EFW400

FONDANT WARMER

FOR YOUR SAFETY:

DO NOT STORE OR USE GASOLINE

OR OTHER FLAMMABLE VAPORS OR

LIQUIDS IN THE VICINITY OF

THIS OR ANY OTHER

APPLIANCE

PLEASE READ ALL SECTIONS OF THIS MANUAL

AND RETAIN FOR FUTURE REFERENCE.

THIS PRODUCT HAS BEEN CERTIFIED AS
COMMERCIAL COOKING EQUIPMENT AND
MUST BE INSTALLED BY PROFESSIONAL

PERSONNEL AS SPECIFIED.

WARNING:

IMPROPER INSTALLATION, ADJUSTMENT,
ALTERATION, SERVICE OR MAINTENANCE
CAN CAUSE PROPERTY DAMAGE, INJURY,

OR DEATH. READ THE INSTALLATION,

OPERATING AND MAINTENANCE

INSTRUCTIONS THOROUGHLY

BEFORE INSTALLING OR

SERVICING THIS EQUIPMENT

INSTALLATION AND ELECTRICAL CONNECTION

MUST COMPLY WITH CURRENT CODES:

IN CANADA - THE CANADIAN ELECTRICAL

CODE PART 1 AND / OR LOCAL CODES.

IN USA – THE NATIONAL ELECTRICAL CODE

ANSI / NFPA – CURRENT EDITION.

ENSURE ELECTRICAL SUPPLY CONFORMS WITH
ELECTRICAL CHARACTERISTICS SHOWN ON

THE RATING PLATE.

Users are cautioned that maintenance and repairs must be performed by a Garland authorized service agent

using genuine Garland replacement parts. Garland will have no obligation with respect to any product that has been

improperly installed, adjusted, operated or not maintained in accordance with national and local codes or installation

instructions provided with the product, or any product that has its serial number defaced, obliterated or removed,

or which has been modified or repaired using unauthorized parts or by unauthorized service agents.

For a list of authorized service agents, please refer to the Garland web site at http://www.garland-group.com.

The information contained herein, (including design and parts specifications), may be superseded and is subject

to change without notice.

GARLAND COMMERCIAL INDUSTRIES

185 East South Street
Freeland, Pennsylvania 18224
Phone: [phone]
Fax: [phone]

GARLAND COMMERCIAL RANGES, LTD.

1177 Kamato Road, Mississauga, Ontario L4W 1X4
CANADA
Phone: [phone]
Fax: [phone]

Enodis UK LTD.

Swallow eld Way, Hayes, Middlesex UB3 1DQ ENGLAND
Telephone: [phone]
Fax: [phone]

Part # 3104500 Rev 01 (01/29/08) © 2005 Garland Commercial Industries, Inc.

Part # 3104500 Rev. 01 (01/29/08) Page 1

GENERAL INFORMATION

Unpacking

Carefully remove unit from carton. Remove all packing
materials, any protective material covering the stainless steel
should be removed immediately after the unit is installed.

Serial Plate Location

Electrical rating is shown on the serial plate and is readily
visible on the rear of the unit next to the power supply cord
inlet.

NOTE: Ensure electrical supply conforms with electrical
characteristics shown on the rating plate.

Safety

• A qualied person must make the installation in
accordance with the authority having jurisdiction and
local codes.

• This unit must only be operated by a qualied person. DO
NOT operate without reading this manual.

• DO NOT operate this appliance unless all service and
access panels are in place and fastened properly.

• DO NOT attempt to repair or replace any part of this
appliance unless all main power supplies have been
disconnected.

• DO NOT clean this appliance unless the power supply is
disconnected.

• DO NOT immerse appliance in water.

WARNING

To avoid serious personal injury:

• USE EXTREME CAUTION in setting up, operating and
cleaning these appliances to avoid coming in contact
with hot surfaces. Suitable protective clothing should be
worn or proper utensils to prevent the risk of burns.

• NOTE all warning labels and markings on this appliance,
which call attention to further dangers and necessary
precautions.

Wall Clearances

Back: 0

Sides: 0

National Code Requirements

The installation and connection should comply with current
codes: In Canada - The Canadian Electrical Code Part 1 and
/ or local codes. In USA – The National Electrical Code ANSI /
NFPA – current edition.

OPERATING INSTRUCTIONS

This appliance has been designed to have water in the tank
for even heating. Before rst use it is recommended that the
inside of the tank be cleaned with a detergent soaked cloth,
to remove fabricating and protective oils. Rinse with clean
water and dry with a clean cloth.

1. Fill the tank with water so that the level is between the
minimum and maximum embossed lines on the inside
wall of the tank.

2. Insert pan with a maximum depth not exceeding 4”
(102mm)

3. Plug appliance into electrical outlet.

4. Turn on appliance with green switch. The appliance will
heat the bath of water and maintain it at 130°F to 140°F
(54° C to 60°C).

Part # 3104500 Rev. 01 (01/29/08)Page 2