Garelick 99128 User Manual

Installation Instructions for

Model 99129/99029 Swing Leg

Form 12.514

Write for
a Complete

Catalog

Phone: [phone]
PO Box 8, 644 2nd Street E-mail: [e-mail]
St. Paul Park, Minnesota 55071 On the Web: www.garelick.com

1/03

Because of the wide variety of applications, mounting
screws are not provided. It is recommended that a
stainless steel screw of suitable length be used for
installation. It should be long enough to penetrate
75% of the substrate thickness without protruding
through the substrate as this could cause injury to a
person sitting on the protruding screw point.

99129 SERIES INSTALLATION

Refer to Fig. 1.

1. The 99129 series swing leg is designed to swing
in two directions: left-right or front-rear.
Determine your application. The recommended
setback from the seat edges is approximately
3". This is a recommendation only and common
sense should be used in determining the exact
position. Depress the spring button and swing
the bracket so the mounting surface is
perpendicular to the leg. Hold the bracket
against the substrate in the desired location and
mark 2 mounting hole positions through the
bracket.

2. Drill 2 pilot holes of a suitable size for the
fasteners selected and mount the swing legs.

NOTE: If the swing legs are going to be mounted

so they swing toward each other, check to
see if they will overlap when folded. If they
overlap they can be installed slightly offset
as to lay beside each other when folded.

99029 SERIES INSTALLATION

Refer to Fig. 2.

1. The 99029 series swing leg is designed to fold
one direction when installed. However, it may
be installed to fold in any direction desired. The
recommended setback from the seat edges is
approximately 3". This is a recommendation
only and common sense should be used in
determining the exact location. Depress the
spring button and swing the bracket so the
mounting surface is perpendicular to the leg.
Hold the bracket in the desired location and
mark 2 mounting hole positions through the
bracket.

2. Drill 2 pilot holes of a suitable size for the
fasteners selected and mount the swing legs.

FIG. 1

FIG. 2

Model 99129

Model 99029