Garelick 75337 User Manual

r

p

Instructions for:
Side Mount Table Hardware

Installation Instructions:

1. Locate mounting bracket in desired

location (note: bracket is made with a 3
degree slant to accommodate most boat
surfaces. If the surface that the bracket is
being mounted due is greater or less than 3
degree the bracket will need to be
shimmed in order to make a level table).

2. Ensure bracket is level, at the desired

height, and mount to the boat surface using
¼” marine grade pan headed fasteners
(Note: fasteners are not provided due to the
large variety of mounting surfaces and
thicknesses).

Caution: Insure area behind bracket
is free of from obstacles such as
fuel tanks, hoses, electrical wires,

etc.
It is recommended that a backer plate or a
suitable substrate be used to handle table
loading. See boat manufacturer
recommendations for location or specific
needs.

Operation Instructions:

1. To insert table assembly pull back on

mounting bracket locking knob and insert
side mount table leg until it is wedges
securely in place.

2. To remove table assembly pull back on

mounting bracket locking knob and pull up
on table leg.

Maintenance:

1. Periodically check and tighten all

mounting hardware attachment points.

2. Ensure cleanliness of equipment to prevent

dirt, rocks, or debris from damaging
sliding surfaces.

Table To

Surface Mount
Adapte

Locking knob – pull out to operate

12.601

Side Mount
Table Pedestal

Mounting Bracket

Write for GARELICK Phone: [phone]
A complete 644 2ND Street, PO Box 8 E-mail: [e-mail]
EEz-In Catalog St. Paul Park, Minnesota 55071 Website: www.garelick.com
02/08