Garelick 75007 User Manual

Assembly and Mounting Instructions for

Model 75007 Clamp Type Swivel Fishing Chairs

Form 12.142

SWIVEL CLAMP ASSEMBLY

1. Take swivel clamp and rotate its top and bottom halves so slots on
bottom plate are exposed (fig. 1).

2. Attach swivel clamp to seat bottom by aligning the holes in the
seat and the slots in the clamp. Secure the clamp in position as
indicated in fig. 1.

CLAMP ADJUSTMENT AND MOUNTING

1. Extend clamp rods (B) and (C) by screwing out both hex nuts (D)
and wing nuts (E) to the extreme ends of the threaded clamp rods
(see fig. 1).

2. Place seat over bench with WING NUTS TO THE REAR (fig. 2).

3. Tighten up clamp as close as possible to bench’s width using
clamp rod (C) and hex nuts (D) first.

4. Secure clamp to bench by tightening wing nuts (E).

SPECIAL MOUNTING SITUATIONS

WIDE BENCHES:
For Benches 12

1

⁄2 inches to 15 inches

On wide benches; sleeve tubes (F) can be cut shorter or
eliminated to give added width to the clamp (fig. 2).

FIG. 3

FIG. 2

FIG. 1

FIG. 4

Write for
a Complete

Catalog

Phone: [phone]
PO Box 8, 644 2nd Street E-mail: [e-mail]
St. Paul Park, Minnesota 55071 On the Web: www.garelick.com

9/01

For Benches 15 Inches to 18 Inches.

On extremely wide benches, remove sleeve tubes (F) from clamp
assembly. Take off both nuts (D) and pull clamp rod out so the rod
ends are exposed in notches as pictured in fig. 3. Thread on both
nuts (D). Make certain that the nuts have threads extending
through their ends. Pull clamp rod out so nuts abut with clamp
washers (G) as pictured in fig. 3.

NARROW BENCHES: On some narrow benches, the clamp rods may
extend beyond the seat. It may be advisable to cut the exposed rods
and file the ends.

TANK TYPE BENCHES: On tank type benches as pictured in fig. 4, it is
recommended that a wood strip be added to the tank and secured in
position as illustrated. This will allow your seat to be mounted securely.

CARE AND MAINTENANCE

• Periodically grease swivel for easy operation.