Garelick 48548 User Manual

Instructions for mounting

Model 48536 – 36" Length x 5" Height
Model 48548 – 48" Length x 5" Height

Cockpit Side Coaming Bolster – Premium White Quilted Vinyl

Form 12.506

Replace or add comfort and padded protection to inside
coaming wall area of any cockpit, especially fish boats!

Note: Before drilling any holes in your boat always check
paper template against back of bolster and make sure
pilot hole locations line up with centers of 1-1/4" holes in back
of bolster. When properly mounted, top of bolster to center of
mounting holes are approximately 2-1/4" and 2-3/4"
respectively as shown in Figure (1).

INSTALLATION

Secure either* 36" or 48" bolster to gunwale coaming as shown
in Figure (1) with use of paper template provided. Tape paper
template in desired position where bolster is to hang and mark
at point A of Figure (2) as shown, repeat for each hole desired
location. Attach upholstery clip (B) fasteners to boat surface.

Insert top edge of each clip into 1-1/4" hole on back of bolster
and push down and in place (See Figure (1)).

These bolsters are somewhat flexible by design and can be used
around moderate curved areas in your boat.

*Both sizes can be used or abutted up to each other to
accomplish desired coverage.

Mounting Hardware

3 (4) - 66.978 Upholstery Clips (B)
3 (4) - 03.168 #8 Screws

Write for
a Complete

Catalog

Phone: [phone]
PO Box 8, 644 2nd Street E-mail: [e-mail]
St. Paul Park, Minnesota 55071 On the Web: www.garelick.com

11/05

FIG. 1

FIG. 2