Garelick 48050 User Manual

Mounting Instructions for

Rotational Molded Poly Seats

Form 12.131

Write for
a Complete

Catalog

Phone: [phone]
PO Box 8, 644 2nd Street E-mail: [e-mail]
St. Paul Park, Minnesota 55071 On the Web: www.garelick.com

3/98

SWIVEL CASTING ATTACHMENT

Mount Swivel Casting to Reinforcement Brackets by inserting
1/4-20 x 1" Screws (A) through Washers (B), Swivel Casting
and Brackets as shown. Secure with Washers (B) and
Locknuts (C). FINGER TIGHTEN ONLY. Make certain Swivel
Casting’s Locking Rod is directed to side of Seat.

Mount Reinforcement Brackets with Swivel Casting to Seat
Bottom with 1/4-20 x 1/2" Screws (D) and tighten.

Using an open-end wrench and phillips-head screwdriver,
finish securing Swivel Casting to Brackets.

SEAT SLIDE ATTACHMENT

Attach the slide by aligning the matching holes in the seat

bottom; secure with appropriate 1/4-20 machine screws.
NOTE: The portion of the screw entering the seat should not
exceed 3/8 inch.

GIMBAL ATTACHMENT

When mounting an EEz-In Model 75011 gimbal to seat, use
the T-nutted holes as illustrated and attach gimbal with
1/4-20 x 1/2" machine screws.

CARE AND MAINTENANCE

This rotational molded poly seat and cushions can be cleaned
with mild soap and a non-abrasive sponge or cloth.
Periodically tighten screws on seat bottom.