Garelick 31400 User Manual

pp

Assembly Instructions for:
31400 Motor Carrier

TOOLS Required: Page 1

Hammer

CAUTION:

Step 1

Insert 4 bolts (2 7/8” long) through wood block. Place
upright handle tubes over bolts so handles point UP
and AWAY from each other.
Tightly secure with fasteners.

Step 2

Slip support brackets on axle attached to U-tube using
large holes.

PO Box 8, 644 2
St. Paul Park, MN 55071

Tubing will crush if over-tightened.

:

:

Support Brackets

Axle

U-tube

nd

Street

Form 12.120

Step 3

Place lower ends of handle assembly INSIDE of arms
of the U-tube at holes.
Insert bolts and finger tighten fasteners.

:

Step 4

Align holes in support brackets with holes in upright
handle tubes.

NOTE: Support bracket is on the outside of the tubes.
Insert bolts and finger tighten fasteners.

:

Fastener

Upright Handle
Tube

Su

Phone: [phone]

E-mail: [e-mail]

On the Web: www.garelick.com

Revision Date: 08/07

ort Bracket

Assembly Instructions for:
31400 Motor Carrier

Page 2
In completion of Step 4, Motor Carrier should be as
shown:

Step 5

Place plastic washer on axel as shown.

Step 6

Place wheel on axel as shown.
Secure with pin.
**Bend pin to secure in place**

PO Box 8, 644 2
St. Paul Park, MN 55071

:

Axel

:

Plastic Washer

nd

Street

Form 12.120

Step 7

Place caps on wheels. Gently tap into place with
hammer.

***Step 8: Tighten all fasteners on carrier.***

Finished Assembly:

Maintenance:

Periodically lubricate wheels and polish** aluminum to
ensure a long life.

NOTE: Recommended for 1-15 h.p./85 lb. motors. For
motors over 5 h.p., mount board on back side of
handle tubes.

:

**EEz-In marine polish, Model 65010, available.

Phone: [phone]

E-mail: [e-mail]

On the Web: www.garelick.com

Revision Date: 08/07