Garelick 19622-61 User Manual

Instructions for: 19622-61, 19623-61

12.610

UNDER PLATFORM TELESCOPING LADDER

MOUNTING INSTRUCTIONS

Thank you for selecting our superior quality Garelick
EEz-In Brand Boarding Ladder. Your ladder was
designed and manufactured using the finest material
available to provide long product life. Choosing the
proper size ladder for location and correct fit is
important to assure safe, convenient, and reliable use.

To select the proper length ladder, choose one that
allows at least two steps under water when ladder is
deployed.

Choose the most suitable side of your transom platform
for mounting the ladder. When mounting, locate a
place where the ladder will not interfere with the
turning of the motor or be near the propeller of your
craft.

See Figure 1

1. Position the mounting bracket with the ladder in

the area to be attached. Mark the bracket’s four
mounting holes onto the deck surface.

2. Drill the four marked holes with a suitable drill bit.

NOTE: It is recommended to through-bolt this
ladder for a secure installation.

3. Mount the ladder in place on one side by putting

the ladder into the bracket and placing it up to the
drilled holes. Insert mounting screws. Secure
ladder in place with fasteners (not provided, as
installations vary).

4. Slide the other mounting bracket, onto the ladder

vertical as before. Center the ladder tubes within
the brackets and make sure they are parallel to
each other. Mark the hole locations of this bracket
onto the deck. Drill holes and secure in place.

When underway, fold ladder up and secure
using the velcro strap provided.

MAINTENANCE

• Safety tip

Periodically check mounting hardware and re­tighten (due to normal boat operation.)

Write for GARELICK Phone: [phone]
A complete 644 2ND Street, PO Box 8 E-mail: [e-mail]
EEz-In Catalog St. Paul Park, Minnesota 55071 Website: www.garelick.com
8/09

• Keep that bright finish!

Local weather conditions may contribute to
minor corrosion. Stainless, like other metals, is
not completely free from corrosion attack.
Regular fresh water rinsing and periodic cleaning
with a mild abrasive cleaner will help to retain
lustre.

SAFETY GUIDELINES

• No jumping or diving!

• Do not use when motor is running

• This ladder designed for boat use only

• Face ladder when entering boat or water

• Only one person on ladder at a time

• Check all steps and hardware before using

• Never operate your boat with the ladder in

“down” position. Serious injury, or damage to
your boat or ladder may result.

Figure 1

FASTENER
SUGGESTION

Note:
Fasteners
not provided

Ladder ships with RE-USEABLE securing
strap holding ladder in stowed position.

DO NOT CUT!
To STOW ladder To DEPLOY ladder