Gardman Garden Arch User Manual

Garden Arch

Assembly Instructions

07720

Components Supplied

Tools Required (not supplied)

Phillips cross-head screwdriver

Mallet

Tape Measure

Before You Start

•Layout all of the component parts and
make sure you have all of the parts listed.

• When you are ready to start, make sure
that you have the right tools to hand,
plenty of space and a clean dry area for
assembly. Always try to assemble the
product as close as possible to the
intended location.

•Remove all plastic bags and dispose of
safely.

•Retain the instructions for future use.

Caution

This pack contains small items which should
be kept away from children.

Consumer Helpline

If you have any problems or queries with
this product then please contact our
helpline number: 01406 372227,
or write to: Gardman Ltd. High Street,
Moulton, Spalding, Lincs, PE12 6QD.
Fax: [phone].

Ref Description Illustration Qty

AStraight tube 8

BT joints 14

C Moisture 10

protection
sleeve

DTop left 2

Curved tubes

ETop right 2

Curved tubes

FStruts 7

GGround hole 1

maker

H Assembly 14

screws

Size: 95cm (3'

1

/

2

")

(approx.)

Size: 41.5cm (1'4")
(approx.)

1. Slide the “T” joints (B) over tubes (A) and
fit moisture protection sleeves (C) as
illustrated to assemble the 8 straight
tubes (A). Slide the moisture protection
sleeve half way onto the female (upper)
joint before pushing the male (lower)
joint into it. Do not secure “T” joints with
assembly screws until you have carried
out section 5 below to allow for final
adjustments.

2. Fit the top curved tubes (D,E) in a similar
way ensuring that the “T” joints are
positioned as illustrated with moisture
protection sleeves fitted. Please also
ensure that the curved tubes are fitted
the correct way round to form a perfect
arch.

3. Connect both halves of the arch with
struts (F) by pushing the struts into
lateral (vacant) slots of “T” joints.

4. Place arch in desired location and mark
leg positions on the ground. Remove
arch and drive hole maker (G) to 0.38m
(1' 3") deep. Remove hole maker and
repeat for remaining legs. Insert legs
into holes and push home. Firm earth
around legs.

5. Carry out final adjustments to strut
positions and secure “T” joints to tubes
using assembly screws (H).

Helpful hints:

You may find it easier to assemble your
arch horizontally on its side and then
carefully stand it upright to install.

Soaking the moisture protection sleeves
in warm water for a few minutes prior to
fitting will make them more malleable
and will aid fitting.

Please note: “T” joints (B) should be
positioned either above or below the
straight tube connection points: do not
attempt to use the “T” joints (B) to
connect the straight tubes (A) together.

Assembly

C

E

A

0.38m

1m

(3'3")

0.47m

(1'6

1

/

2")

1.9m

(6'3")

0.38m

(1'3")

All sizes approx.

BELOW GROUND

HEIGHT ABOVE

GROUND

WIDTH

DEPTH

TOTAL HEIGHT BEFORE FITTING:

2.28m

(

7

'

6

"

)

A

D

B

F

G

Joint

Moisture

Protection

Sleeve