Gardman Gallic Arch User Manual
Gallic Arch
Assembly Instructions
07735
Components Supplied
Tools Required (not supplied)
Phillips cross-head screwdriver
Mallet
Tape Measure
Before You Start
•Layout all of the component parts and
make sure you have all of the parts listed.
• When you are ready to start, make sure
that you have the right tools to hand,
plenty of space and a clean dry area for
assembly. Always try to assemble the
product as close as possible to the
intended location.
•Remove all plastic bags and dispose of
safely.
•Retain the instructions for future use.
Caution
This pack contains small items which should
be kept away from children.
Consumer Helpline
If you have any problems or queries with
this product then please contact our
helpline number: 01406 372227,
or write to: Gardman Ltd. High Street,
Moulton, Spalding, Lincs, PE12 6QD.
Fax: +44 (0) 1406 372233.
Ref Description Illustration Qty
AStraight tube 8
BT joints 14
C Moisture 10
protection
sleeve
DTop left 2
Curved tubes
ETop right 2
Curved tubes
FStruts 7
GGround hole 1
maker
H Assembly 14
screws
Size: 1.05m x 19mm
(3'5
1
/
2
x
3
/
4
")
(approx.)
Size: 0.41m x 16mm
(16" x
1
/
2
")
(approx.)
1. Fit the "T" joints (B) and moisture
protection sleeves (C), as illustrated, to
assemble the 8 leg tubes as shown. Slide
the sleeve half way onto the female
(upper) joint before pushing the male
(lower) joint into it. Do not secure "T"
joints with screws until section 5 below
to allow for final adjustments.
2. Fit the top curved tubes (D and E) in a
similar way ensuring that the "T" joints
are positioned as illustrated with
joint/moisture protection sleeves
(C) fitted.
3. Connect both halves of the arch with
struts (F) by pushing the struts into the
vacant "T" joint slots.
4. Place arch in desired location and mark
leg positions on the ground. Remove arch
and drive hole maker (G) to a
recommended depth of approximately
0.38m (1' 3"). Insert legs into holes and
firm earth around to secure.
5. Carry out final adjustments to strut
positions and secure "T" joints to tubes
using assembly screws.
Helpful hints:
You may find it easier to assemble your
arch horizontally on its side and then
carefully stand it upright to install.
Soaking the moisture protection sleeves
in warm water for a few minutes prior to
fitting will make them more malleable
and will aid fitting.
Please note: “T” joints (B) should be
positioned either above or below the
straight tube connection points: do not
attempt to use the “T” joints (B) to
connect the straight tubes (A) together.
Assembly
0.38m
C
B
A
H
D
E
F
G
Joint
Moisture
Protection
Sleeve
1.22m
(4'
1
/
2
")
0.48m
(1'7")
2.06m
(6'9")
0.38m
(1'3")
All sizes approx.
BELOW GROUND
HEIGHT ABOVE
GROUND
WIDTH
DEPTH
TOTAL HEIGHT BEFORE FITTING:
2.44m
(8')
Loading...