Gardman Easy Arch User Manual

Easy Arch

Assembly Instructions

07707

Components Supplied

Tools Required
(not supplied)

Phillips cross-head screwdriver

Mallet

Tape Measure

Before You Start

•Layout all of the component
parts and make sure you
have all of the parts listed.

• When you are ready to start,
make sure that you have the
right tools to hand, plenty of
space and a clean dry area
for assembly. Always try to
assemble the product as
close as possible to the
intended location.

•Remove all plastic bags and
dispose of safely.

•Retain the instructions for
future use.

Caution

This pack contains small items
which should be kept away
from children.

Ref Description Illustration Qty

AStraight tube 2

BStraight tube 2

CStraight tube 12

D Curved tube 8

ECross bars 11

F Assembly 22

screws

Consumer Helpline

If you have any problems or queries with this product
then please contact our helpline number:
01406 372227,
or write to:
Gardman Ltd. High Street,
Moulton, Spalding, Lincs, PE12 6QD.
Fax: [phone].

1. Slot together tubes (A, B, C and D)
as shown to form one side of the arch.
Ensure screw holes for cross bars (E) line
up. (See inset) Note: Tubes A and C have
one male and one female end, B has two
female ends.

2. Repeat step 1 for the other side.

3. Fit one end of all cross bars (E) to one
side of the arch as shown
(See inset) using assembly screws (F).

4. Fit other side of arch to remaining
ends of cross bars (E).

5. Place assembled arch in desired
location. If the ground is soft the
arch can be pushed into the ground.
Where the ground is particularly hard
fitting can be aided by either watering
the ground or pushing a suitable rod or
spike in first. A depth of approximately

0.40m (1' 4") is recommended.

Helpful hints:

You may find it easier to assemble your
arch horizontally on its side and then
carefully stand it upright to install.

If the screw holes on the poles are
covered with a thin layer of the
protective coating, carefully remove
this by pushing a small nail through
the coating.

Assembly

C

B

D

F

A

E

1.4m

(4'7")

0.37m

(1'2")

All sizes approx.

WIDTH

DEPTH

TOTAL HEIGHT BEFORE FITTING:

2.4m

(

7

'

10

")

BELOW GROUND

0.40m

(1'4")

2m

(6'6")

HEIGHT ABOVE

GROUND