Gardman Aztec Falls Indoor User Manual

19041 Aztec Falls Indoor Water Feature

Water Feature place of purchase (Retailer):

Date of Purchase:

Purchase Price:

Please read the assembly instructions and separate pump instructions carefully prior to installation.

Assembly Instructions

 Unpack all the water feature components from the packaging and lie on a flat surface.
 Take the top part of the feature (1) and attach the pump (3) to the rubber tube (2) that is located on

the underside, and then lay the pump inside on the base (4) of the feature. Make sure the tube is
properly connected and is not kinked.

 The pump flow can be adjusted with the switch (5) which is located on the inlet of the pump.
 Position the cable through the cable slot located (6) on the top part of the water feature base plate.

Do not insert the plug (7) in to the mains at this time.

 Fill the reservoir with water to 1.5cm (1/2”) from the top. We recommend using warm water to

prevent mineral build up.

 Set the top part of the water feature onto the base so it sits level.
 Insert the plug/transformer in to the power socket and switch on. If installed correctly water will

start to flow from the feature. Please note: On first use, there may be air in the pump and it may take
a few moments for the water to come through.

www.gardman.co.uk

19041 Aztec Falls Indoor Water Feature

Water Feature place of purchase (Retailer):

Date of Purchase:

Purchase Price:

Care & Cleaning

 Clean the feature in a mixture of vinegar and water to remove any mineral build up.
 Always turn your water feature off if leaving your home for a sustained period of time.

Troubleshooting

Note: Always switch off and disconnect the plug/transformer from the electrical outlet before handling the
pump.

1) If the pump starts to lose power or fails to operate, check the following;

a) Check if sufficient water is inside the reservoir.
b) Check the pump and tubing for any obstructions.
c) Check the fuse in the plug or try a different power outlet to make sure the pump is receiving

electrical power.

d) Remove the pump inlet cover to access the impeller area. Turn the rotor gently to ensure it is not

broken or jammed (please revert to your separate pump instructions for further information).

2) If the pump gurgles or spews;

a) Check the water level to make sure the pump has enough water to function and ensure the water in

the water reservoir is always at the correct level.

3) If water is splashing outside the fountain or the pump is running with slow water circulation check

the following;

a) Adjust the flow control switch located on the inlet of the pump accordingly for a more suitable flow

rate.

b) Make sure the pump is completely submersed in water.

www.gardman.co.uk