Gardena 7944 User Manual

GBFNLS

GARDENA

D Gebrauchsanweisung

Eisfreihalter IP 300

GB Operating Instructions

Anti-Frost Pump IP 300

F Mode d’emploi

Pompe stop-glace IP 300

NL Gebruiksaanwijzing

IJsvrijhouder IP 300

S Bruksanvisning

Vinterpump IP 300

I Istruzioni per l’uso

Set antigelo per laghetti IP 300

E Manual de instrucciones

Bomba anti-heladas IP 300

P Instruções de manejo

Bomba anti congelamento IP 300

DK Brugsanvisning

Pumpe til isfri vand IP 300

Art. 7944

m 1,0

0,8

0,6

0,4

0,2

bar

0,10

0,08

0,06

0,04

0,02

012345678l/min

GARDENA Anti-Frost Pump IP 300

Welcome to GARDENA aquamotion ...

Please read these operating instructions carefully and observe the notes given. Use the instructions to familiarise yourself with the equipment, the operating controls, their correct use, and the notes on safety.

For safety reasons, children under 16 as well as persons not familiar with these operating instructions should not use this pump.

Keep these operating instructions in a safe place.

The Applications Range of Your Pump

GARDENA Anti-Frost Pumps have been designed for private use around your house. They are not designed for operating watering tools and systems.

A GARDENA Anti-Frost Pumps have not been designed for

constant use in the industrial sector. Corrosive, easily combustible, aggressive or explosive substances (e.g. petrol, petroleum, nitro thinner) as well as salt-water or food / drinking water must not be pumped.

Intended purpose

Attention

A For Your Safety

The pump should be operated via a residual current device with a residual current rating of ≤ 30 mA (DIN VDE 0100-702 and 0100-738). The pump must be placed on solid, even ground. Please ask your electrician for his advice.

Mains power cables should not have a smaller cross-section than a rubber sheathed cable of the designation H05 RNF. Extension cables must meet the requirements of DIN VDE 0620.

In Austria power cables should correspond to ÖVE-EM 42, T 2 (2000) /1979 § 22 according to § 2022.1. According to this standard pumps used in swimming pools and ponds should only be operated via an isolating transformer. Please contact your electrician.

In Switzerland mobile appliances which are used outdoors, must be connected via a residual-current device.

Before operating the pump, look to see if there is any damage of the pump (esp. regarding power cable and plug). A damaged pump must not be used. In case of damage, please have the pump checked by our GARDENA Service Centre or by an authorised electrician.

Operating the pump

Mains power cables

For Austria

For Switzerland

Visual check

Check line voltage. Data indicated on the type plate must match technical data of the mains supply.

The pump must not be operated when there are people in the water.

Swimming pools and garden ponds should be designed according to international and national design regulations. Please consult a professional electrician.

Do not use the power cable to carry the pump or to pull the plug out of the socket. Protect the power cable from heat, oil and sharp edges.

Please unplug the pump after operation and before carrying out any maintenance works.

The temperature of the liquid used should not exceed 35°C.

Sand and other abrasive substances in the liquid cause increased wear and reduce the output of the pump.

Check line voltage

Do not operate pump when there are people in the water

Swimming pools and garden ponds

Do not use power cable to carry the pump

Disconnect plug

Temperature of the liquid used

Wear and reduced output

Assembly

Push the pressure joint of the pump from the inside through the opening of the folding filter (the pump volume regulator must be set at “max.”).

Push the hose end adaptor from the outside onto the pressure joint. Push the hose onto the hose end adaptor and fix it with the hose clip. If necessary, straighten the hose in warm water.

Then re-fold the folding filter.

+ 11 hidden pages