Ganz ZN-PTZ12VN-XT User Manual
1) Connect the LAN cable and power supply cable with
the camera. For the detailed information, please refer
to the Step 2.
2) Place the installation template (which is included in
the package) on the ceiling.
3) Drill four holes on the template and insert anchor
blocks into the holes. Fasten the surface mount bracket
with screws.
4) Put the main body on the surface mount bracket of
the camera. Make sure the bracket and the main body
fit each other into place.
5) Fasten the main body with screws.
When assembling the main body of the camera and its dome cover, make sure they
fit each other into place.
The camera may fall off the ceiling even after the proper installation and mounting.
To prevent any accident, make sure the ceiling is firm and stable enough to support
the camera. If any reinforcement is needed, consult with your safety personnel and
proceed with the installation.
Caution
!
Quick Installation Guide
This manual has been designed to guide you through basic settings of your IP devices, such as installation and
configuration for using them.
Step1. Assemble and install IP device
EC551 Ver1.0
1
LAN Cable
* Models herein and their appearance
are subject to change without any prior
notice.
In
Out
AUDIO
DI
DO RS-485
12VVout
In
Out
AUDIO
DI
DO RS-485
12V
Vout
Make sure the polarity is correct. Incorrect connection may
cause malfunction or damage to the IP device.
Caution
!
Power Adaptor Connector (DC 12V)
DC 12V
Reset Button
Step2. Connect cables to IP device
Connect each cable to the device. To see the correct positions of all connectors, refer to the following image
below.
EC551 Ver1.0
2
Step3. Set up network environment
The default IP address of your IP device is 192.168.XXX.XXX. You can find the available IP address from the
MAC address of your device. Please make sure the device and your PC are on the same network segment
before running the installation. If the network segment was different between your PC and the device, change
your PC’s settings as below.
IP address : 192.168.xxx.xxx
Subnet mask: 255.255.0.0
EC551 Ver1.0
3
Loading...