Ganz ZN-D1MTP, ZN-D2MTP-IR, ZN-D2MTP User Manual

Quick User Guide ZN-DxMTP Network Camera

Warning before installation

-Power off the Network camera if it is found to be smoking or smells unusual.

-Keep the Network camera away from water. If the Network camera gets wet,
power off immediately.

-Do not place the Network camera near heat sources, such as a television or
oven.

-Refer to your instruction manual for the operating temperature.

-Keep the Network camera away from direct sunlight.

-Do not place the Network camera in high humidity environments.

-Do not place the Network camera on unsteady surfaces.

-Do not touch the Network camera when there is lightning present.

-Do not disassemble the Network camera.

-Do not drop the Network camera.

-Do not insert any object into the Network camera, such as a screwdriver.

For other safety and regulation information, please refer to “User’s manual”.

1. Check Contents

No. Item Description

1 Network Camera ZN-DxMTP Series (ZN-D2MTP / ZN-D1MTP)
2 Software CD User’s Manual, Utility software
3 Quick User Guide This document
4 Accessories Template for installation

Video monitor cable
Tapping Screw 4x30 : 2pcs
Anchor : 2pcs
Tapping Screw for middle cover 3x8 : 2pcs
Network extension cable
Power cable

2. Physical Description

Ver1.00 EN

1

Quick User Guide ZN-DxMTP Network Camera

1. Network (RJ-45 PoE supported)

2. Power (DC12V / AC24V)

3. I/O signal terminal block

-Audio In (Line in)

-Audio Out (Line Out)

-Alarm In (Dry Contact)

-Alarm Out (Relay out [0.5A:AC125V/1A DC30V])

4. Control Button

5. Video output for service monitor

6. Status LED

3. Making Connection

1. If you have external devices such as sensor or alarms, make connection
from connectors.

2. Connect Ethernet cable to make connection to the network hub.

3. Connect power cable to the camera.
When you use PoE function, you don’t need to connect power.

Ver1.00 EN

2