Ganz BC-IR3.6N / BCH-IR3.6N, BC-IR3.6N User Manual

1

PRODUCT FEATURES

1. Selection of 420 and 520TV resolution and low light performance surveillance
camera with a built-in 1/3 type CCD

2. Integrated 3.6mm fixed lens

3. Outstanding 0.15/0.30 lux performance with built-in 24 LEDs.

4. Photocell activates IR light at night.

5. Compact and light weight

6. Designed for indoor or outdoor use

SAFETY PRECAUTIONS

OUTDOOR IR COLOR CAMERA

MODEL: BC-IR3.6N / BCH-IR3.6N

5. The installation should be made
by qualified service engineers
and should conform to all local
codes.

6. To prevent fire or electric shock,
do not expose the camera to rain
or moisture.

7. To prevent fire or electric shock,
UL listed wiring should be used
for the DC 12V input.

8. Use only DC 12V regulated
power supply marked class 2.

9. Never attempt to disassemble or
modify the camera.

1. Be sure to connect each lead to the
appropriate terminal. Wrong
connection may cause damage to
the camera.

2. Do not attempt to aim the camera
at the sun or other extremely
bright objects.

3. Do not allow the camera to be
subject to unstable location, strong
shocks and vibration, and strong
electromagnetic field.

4. If any abnormality occurs,
immediately turn off the power
and consult your dealer.

2

1
2

INSTALLATION

1. Use the supplied three screws to attach the bracket to wall. Drill a hole in advance on the proper
position of the wall for the Power and Video Cable to pass through later.

2. Remove the Joint Lock from the bracket by turning it counterclockwise. Then, screw the Joint Lock
to the backside of the camera (turn clockwise)*.

* There are two screw holes on the backside of the camera. Please choose the proper one which best
suits your installation environment. If the upper screw hole is chosen, it’s recommended to push the
Sun Shield a little bit toward the direction of the lens for easy installation.

3. Screw the camera with the Joint Lock connected to the bracket. Adjust the camera angle and the
Sun Shield position. After that, secure the Joint Lock to fix. Then, pass the Power and Video Cable
through the hole drilled in Step 1 to hide it.

CONNECTION

1. Video Output Connector (VIDEO OUT)

Connect the camera video output and the monitor

video input with 75Ω coaxial cable.

2. DC12V Input T erminal

Connect the power terminal of the camera to a 12V
DC regulated power supply.

Note:

Please use the correct power adaptor, DC12V
(regulated), to operate this unit. The power
tolerance of this unit is DC12V ± 10%. Over
maximum DC 12V power input will damage this unit.

Joint Lock

Sun Shield

Power and Video Cable