Interface 1000
QUICK-START GUIDE
USB Potentiostat Installation
Guide #2
When possible, connect the Chassis Ground on the back of your
potentiostat to a known, good earth ground.
Connect the cell cable to the Calibration side of the UDC4 dummy cell
included with your instrument.
Place the dummy cell inside the Calibration
Shield, close the lid, and connect the black
oating-ground lead of your cell cable to the
Shield’s grounding post.
Open Gamry Framework™. Select Experiment > Utilities > Calibrate Instrument
Choose your potentiostat. Select the radio button for calibration type Both, and click the OK button.
(Even though AC calibration for the
Interface™ 1000 is performed at the
Factory, be sure to click the Both radio
button.)
After you conrm several instructional
messages, the calibration proceeds
automatically, and you are notied if the
calibration is successful.
Did you receive a
CALIBRATION WARNING?
TROUBLESHOOTING A FAILED CALIBRATION
Calibration is used to check the potentiostat’s health, and to “zero” many of the measurement circuits to
your laboratory environment. A warning does not necessarily indicate a critical failure, and Gamry can
use calibration information to determine the source of the warning.
Double-check the following:
• Regular connections are to Calibration side of the UDC4.
• Floating-ground cable is connected to calibration shield.
• If possible, the Chassis Ground is attached to a known, good earth ground.
Click the Retry button, and the rest of the calibration restarts. Click the Ignore button for
any other calibration warnings that may appear, and continue to Step 3.
After a failed calibration attempt:
• Find Calibration Results PC6-#####.txt in your My Gamry Data folder.*
• E-mail the le, along with complete contact information, to techsupport@gamry.com
* ##### is the serial number of your potentiostat.
WHAT DOES GAMRY SOFTWARE DO?
Gamry Framework
Potentiostat control for exible data aquisition.
Select from standardized experiments grouped
by research type, or use the Sequence Wizard to
build complex automated experiments.
Echem Analyst
Quick and easy data analysis. Open data les
with Echem Analyst for specialized analysis
algorithms and high-quality plots. Customize,
overlay, and scale plots, or export data.
My Gamry Data
The default data-folder location for Gamry
Framework, with a shortcut on your desktop
after installation. Change the folder location
within Gamry Framework via Options > Path.
Virtual Front Panel
Software-based front panel for quick access
to Gamry potentiostats’ functions, like a front
panel of an early analog potentiostat; and to
perform simple electrochemical experiments.
Electrochemical Signal Analyzer
TM
TM
TM
TM
TM
Designed specically for the acquisition and
analysis of time-dependent electrochemical
noise signals.
Resonator
Data-acquisition and -control software for the
Gamry eQCM™. Contains a full suite of physical
electrochemistry techniques.
Electrochemistry Toolkit
A sophisticated package for complete access to
the capabilities of Gamry potentiostats in the
software environment of your choice.
TM
TM
Calibration QSG: USB Potentiostat 1000 - 988-00024 rev. 2 - Gamry Instruments © 2016
Loading...