• Do not leave the humidier “ON” unattended.
• Never cover the humidier when operational as this could damage the unit. Do not cover any
openings of the unit or insert objects into any of the openings
• Do not add aromatherapy oils into the nozzle, base or water tank.
• Do not tilt or tip unit or attempt to empty or ll it while it is operating.
• Do not immerse the humidier in water or let water come into contact with the connector, or
control device.
• Do not attempt to open any part of the humidier.
• Keep the humidier clean. Do not allow objects to enter the ventilation, as this may damage the
unit.
• Close supervision is required when any appliance is used near or by children.
• Never allow the cord to touch wet or hot surfaces, become twisted or be within the reach of
children.
• Do not place on or near hot gas or an electric burner.
• Never use the appliance with a damaged cord or plug or after the appliance has malfunctioned
or been damaged in any way.
• Never attempt to open any part or dismantle the controls. Responsibility for failure cannot be
accepted if these instructions have been ignored. The repairs can only be carried out in the service
centre the address of which is stated in the guarantee card.
• The unit should not be left unattended in closed rooms as air could become saturated and leave
condensation on walls or furniture.
• Do not use detergent to clean any parts containing water. The detergent can interfere with the
output of the unit if it comes into contact with the water.
• Always leave room door partly open.
1. Carefully remove your humidier from the carton, and take o all the protective wrapping.
2. Place the humidier on a rm, level surface free from obstructions.
3. For rst using, please put the humidier in a room with normal temperature. After half an hour,
it can be operated.
4. Working temperature: 5
0
-400С, relative humidity: ≤80%RH
5. Using water less than 400С ( puried water is recommended).
6. Remove the water tank from the base of unit, open the cap and ll from bottom with water.
7. Close the cap and put the water tank on the base correctly.
8. Put the nozzle in the notch of water tank and adjust the nozzle away from walls and furniture.
9. Plug the humidier into a power outlet.
10. To turn on the humidier (never switch it on without water). The power indicator will illuminate.
You may see the status bar from the screen. It shows the highest mist output, humidication display, current room temperature and current humidity.
11. If setting dierent modes, press the button of “mode setting”. There are four modes: standard/
health/skin care/humidication. It is convenience for people to choose.(Under mode “Humidication”, mist intensity is the highest.)
- Standard (Std.): According to room temperature, it will control the humidity and restrain the virus.
- Health (Helt.): The humidity level will be controlled at about 60% RH, that will be comfortable to
people.
- Skin Care (Skin): The humidity level will be controlled at about 70%RH. It can help people to dispel
crinkle.
- Humidication (Hum.): It will be at the position of spray without the inuence of environment
humidity.
12. Press the button of Mist intensity control, you can set 4 levels of mist intensity according to
your room.
13. Press the button of Humidity Setting. Set humidity comfortable for you. When the room humidity is higher than that shows on the screen, the humidier will stop to spray. Once the room humidity is lower than which shows on the screen, the humidier starts to spray again.